Abstract:It has been recognized that purposefully designed surface texturing can contribute to the improvement of tribological performance of elements and friction reduction. However, its optimal parameters may depend on the operating conditions. This paper investigated the effect of a triangle-shaped dimples array on the tribological performance of the lubricated point-contacts under different lubrication regimes, based on the rotational sliding experiment of a patterned steel disk against smooth steel balls. The dimples arrays were produced by laser process and characterized by the 3D profilometer. A series of tests were conducted with different dimple parameters including depth, coverage ratio, size, and direction. Stribecklike curves were obtained to depict the transition of lubrication regimes, and the electrical contact resistance was utilized to qualitatively characterize the lubrication status. The test results showed that the dimples arrays with different sizes, depths and coverage ratios had a distinct effect on the friction behaviors. Compared with the nontextured surfaces, when the dimple depth decreased from 30μm to zero with fixed coverage ratio and size, the friction coefficient firstly decreased, and then increased. The friction coefficient finally approached that of the nontextured surface, during which the lowest value appeared at the dimple depth of approximately 10∼15μm. The coverage ratio of texture showed the similar effect on the friction coefficient. Usually, the coverage ratio of approximately 10% resulted in the lowest friction coefficient. The dimple size and direction also had obvious effects on the friction coefficient. Thus, it can be concluded that there exists a set of optimal values for the dimple depth, coverage ratio, size, and direction to realize the friction reduction.

Effect of Surface Texturing on Lubrication Performance of Ball - on - Disc Point Contacts

Investigation of Patterned Textures in Ball-On-Disk Lubricated Point Contacts

Experimental Study of the Effect of Surface Texturing on the Lubrication Performance in Point Contacts

Effect of Different Textured Surfaces on Lubricating Characteristics of Area Contact Friction Pairs.

Experimental Investigation on Effects of Surface Texturing on Lubrication of Initial Line Contacts

Effects of Oil Feeding on Lubrication Performance in Point Contacts of Micro -textured Surfaces

The Effect of Surface Texturing on Reducing the Friction and Wear of Steel under Lubricated Sliding Contact

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

Numerical Simulation and Experimental Investigation on Tribological Performance of Micro-Dimples Textured Surface under Hydrodynamic Lubrication

Effect of surface texture on the frictional properties of grease lubricated spherical plain bearings under reciprocating swing conditions

Influence of Surface Roughness on the Friction Property of Textured Surface

Effect of the Parameters of Surface Textures on the Hydrodynamic Lubrication Characteristics of Radial Bearing

Numerical Investigation of the Tribological Performance of Micro-Dimple Textured Surfaces under Hydrodynamic Lubrication

The Effect of Triangle-Shaped Surface Textures on the Performance of the Lubricated Point-Contacts

The Effect of Surface Textures on Loading Capacity of Journal Bearing Lubricating Film

Numerical and Experimental Study of a Sector-Shaped Surface Texture in Friction Reduction

Efficiency of surface texturing in the reducing of wear for tests starting with initial point contact

Effect of Surface Texture Distribution Parameters on Hydrodynamic Lubrication and Numerical Optimization

Effects of Surface Texture on Turbulent Lubrication of Water-lubricated Journal Bearing

The Influence Of Surface Texturing On The Transition Of The Lubrication Regimes Between A Piston Ring And A Cylinder Liner

Experimental Verification of Simulation Analysis Method on Antifriction and Lubrication Performance of Surface Texture