Abstract:JAERI has been proposing a high-intensity proton accelerator with energy of 1.5GeV and a beam power of 8 MW for the Neutron Science Project (NSP)[1]. This paper describes a conceptual design study for the RF system; a candidate of amplifier for the low energy accelerating part, an RF system efficiency and required AC power are estimated for the high energy a ccelerating part. 1 RF SYSTEM OF NSP ACCELERATOR The NSP is aiming at exploring nuclear technologies for nuclear waste transmutation and various basic research fields such as condensed matter physics based on a proton induced spallation neutron. The accelerator will consist of RFQ, DTL for the low energy part and superconducting (SC) linac for the high energy part. It should be operated both in pulse and CW. The RF system is most costly part for a high power RF accelerator and one of the major components to determine the reliability. The accelerator is required with CW operation for application of the nuclear waste transmutation, and is required with high current pulse operation for the basic research field. This requirement is the essential feature of the NSP accelerator. A preliminary specific at on for the accelerator is given in Table 1. The final value of energy/current and pulse time structure will be determined from further discussion on the user requirement and the cost estimation. Figure 1 shows a block diagram of an RF system for the NSP accelerator. As a main option, we chose a frequency combination of 200 600 MHz for the accelerator. There is three times frequency jump between low and high energy part. In the first consideration, we chose a klystron system in the 600 MHz part. Klystrons are widely used as high power RF source and are regarded as a reliable device. Grid tubes such as a tetrode and a Diacrode will be applied in 200 MHz part. In the conceptual design, the accelerator requires the total peak RF power of about 300 kW for RFQ, 9MW for DTL and 29 MW for SC linac for the pulse operation.

Title: EXCESS RF POWER REQUIRED FOR RF CONTROL OF THE SPALLATION NEUTRON SOURCE (SNS) LINAC, A PULSED HIGH-INTENSITY SUPERCONDUCTING PROTON ACCELERATOR

Excess RF Power Required for RF Control of the Spallation Neutron Source (SNS) Linac, a Pulsed High-Intensity Superconducting Proton Accelerator

EXCESS RF POWER REQUIRED FOR RF CONTROL OF THE INTENSITY SUPERCONDUCTING PROTON ACCELERATOR

Analysis and Synthesis of the SNS Superconducting RF Control System

FOR A PHOTO-NEUTRON SOURCE DRIVEN BY 15 MeV ELECTRON LINAC

Preliminary Design of CSNS-II Linac SRF LLRF

An RF power system for NSP high intensity proton accelerator at JAERI

An Overview of the Spallation Neutron Source Project

Uncertain System Modeling of SNS RF Control System

rf improvements for Spallation Neutron Source H- ion source

China spallation neutron source design∗

Design of a compact RFQ linac for the transportable neutron source

The NSNS High Energy Beam Transport Line

RF H-Minus Ion Source Development in China Spallation Neutron Source

High duty factor plasma generator for CERN's Superconducting Proton Linac

Design of a CW high charge state heavy ion RFQ for SSC-LINAC

Design and study of a continuous wave RFQ for the BISOL high intensity deuteron driver linac

Resonance Control Cooling System for a Proto-Type Coupled Cavity Linac

A Particle-In-Cell Scheme of the Rfq in the Ssc-Linac

Beam Dynamics Pre-Study For The Rfq Of Sppc P-Linac

Commissioning and operation of the transverse collimation system at the RCS of CSNS