Abstract:One of the basic problems in the design of polymer extrusion dies for multi-lumen micro profiles is the previously unknown extrudate swells, since they are more complex than those in axisymmetric extrusions. To investigate the three-dimensional extrudate swell of such geometries, numerical simulations and experiments are performed for the extrusion of a double-lumen micro profile using polypropylene. The selected profile exhibits typical non-axisymmetric geometry, uneven thickness and micro-scale dimension. A double convected pom–pom model considering the micro size effect is proposed to characterize viscoelastic properties of the polymer melt. Predictions are compared with experimental results as well as simulations using the power law model, and show the capacity of the proposed model for assessing the anisotropic swelling quantitatively. Influences of micro size effect, volumetric flow rate and material parameters on extrudate swell are investigated by parametric studies. It is found that swell ratios of various positions on the extrudate cross section are significantly different. The swelling anisotropy degree is enhanced with increasing volumetric flow rate as well as material parameters of second normal force coefficient and branching degree, while it is suppressed as the ratio of orientation to stretching relaxation time increases. The influence mechanisms of material parameters on extrudate swell are also discussed in detail. It is suggested that the anisotropic extrudate swell induced by micro size effect is significant and should be taken into account in high accuracy micro profile extrusions.

Measurement and Simulation of Low‐density Polyethylene Extrudate Swell Through a Circular Die

Finite-element simulation of polymer flow and extrudate swell through hollow profile extrusion die with the multimode differential viscoelastic model

Numerical Investigation of Die Geometry Effect on Ldpe Annular Extrudate Swell

Continuous Modeling and Simulation of Flow-Swell-crystallization Behaviors of Viscoelastic Polymer Melts in the Hollow Profile Extrusion Process

Numerical Simulation of Viscoelastic Extrudate Swell Through Elliptical Ring Die

Numerical simulation of extrudate swell of the IUPAC-LDPE melt by using Cross model

Three-Dimensional Viscoelastic Simulation of the Die Swell in Coextrusion Process

The Numerical Analysis of Die Swell and Recoverable Elastic Strain in Polymer Coextrusion Process

Experiment and Numerical Simulation of Extrudate Swell in the Polymer Extrusion Process

Numerical simulation of die swell in double-layer polymer

Three-dimensional Numerical Simulation of Extrudate Swell of Polymer Melts

Modeling and Simulation of Three‐dimensional Extrusion Swelling of Viscoelastic Fluids with PTT, Giesekus and FENE‐P Constitutive Models

Numerical Simulation of Die Swell in Gas-assisted Pipe Extrusion

Study on extrudate swell of polypropylene in double-lumen micro profile extrusion

The polymer melt swelling behavior in micro-extrusion process for preparation of continuous carbon fiber reinforced PP prepreg filament

A New Short Die Swell Equation for Polymer Extrusion

The Full Three Dimensional Isothermal Viscoelastic Numerical Simulation on the Extrusion Die Swell of Polymer Profile

Numerical Investigation on the Influence of Melt Viscoelasticity on Die Swelling of Polymer Co-extrusion Process

Three-Dimensional Nonisothermal Numerical Simulation of Die Swell in Gas-Assisted Coextrusion Process with Viscoelastic Fluids

Numerical Simulation of Three‐dimensional Polymer Extrusion Flow with Differential Viscoelastic Model

Modeling of the Molecular Weight Distribution and Short Chain Branching Distribution of Linear Low-Density Polyethylene from a Pilot Scale Gas Phase Polymerization Process