Abstract:One of the basic problems in the design of polymer extrusion dies for multi-lumen micro profiles is the previously unknown extrudate swells, since they are more complex than those in axisymmetric extrusions. To investigate the three-dimensional extrudate swell of such geometries, numerical simulations and experiments are performed for the extrusion of a double-lumen micro profile using polypropylene. The selected profile exhibits typical non-axisymmetric geometry, uneven thickness and micro-scale dimension. A double convected pom–pom model considering the micro size effect is proposed to characterize viscoelastic properties of the polymer melt. Predictions are compared with experimental results as well as simulations using the power law model, and show the capacity of the proposed model for assessing the anisotropic swelling quantitatively. Influences of micro size effect, volumetric flow rate and material parameters on extrudate swell are investigated by parametric studies. It is found that swell ratios of various positions on the extrudate cross section are significantly different. The swelling anisotropy degree is enhanced with increasing volumetric flow rate as well as material parameters of second normal force coefficient and branching degree, while it is suppressed as the ratio of orientation to stretching relaxation time increases. The influence mechanisms of material parameters on extrudate swell are also discussed in detail. It is suggested that the anisotropic extrudate swell induced by micro size effect is significant and should be taken into account in high accuracy micro profile extrusions.

Experiment and Numerical Simulation of Extrudate Swell in the Polymer Extrusion Process

The Numerical Analysis of Die Swell and Recoverable Elastic Strain in Polymer Coextrusion Process

Numerical simulation of filling flow of polymer melt in injection molding

Numerical Simulation of Viscoelastic Extrudate Swell Through Elliptical Ring Die

The polymer melt swelling behavior in micro-extrusion process for preparation of continuous carbon fiber reinforced PP prepreg filament

Numerical simulation of die swell in double-layer polymer

The Finite Element Simulation and Analysis of Polymer Tube Coextrusion Process

Measurement and Simulation of Low‐density Polyethylene Extrudate Swell Through a Circular Die

Finite-element simulation of polymer flow and extrudate swell through hollow profile extrusion die with the multimode differential viscoelastic model

Experiment and Simulation for Extrustion Swell in Gas-assisted Extrusion

Three-dimensional Numerical Simulation of Extrudate Swell of Polymer Melts

The Full Three Dimensional Isothermal Viscoelastic Numerical Simulation on the Extrusion Die Swell of Polymer Profile

Numerical simulation of extrudate swell of the IUPAC-LDPE melt by using Cross model

Continuous Modeling and Simulation of Flow-Swell-crystallization Behaviors of Viscoelastic Polymer Melts in the Hollow Profile Extrusion Process

Study on Extrudate Swell in Polymer Bicomponent Coextrusion Process

Numerical Investigation of Die Geometry Effect on Ldpe Annular Extrudate Swell

Numerical Investigation on the Influence of Melt Viscoelasticity on Die Swelling of Polymer Co-extrusion Process

Study on extrudate swell of polypropylene in double-lumen micro profile extrusion

Study of Die Swell of Gas-assisted Extrusion of Polymer

Effect of the Vibration Force Field on the Polymer Extrusion Swell

Numerical Simulation of the Extrusion Forming Dynamic Process of Polymer Material