Abstract:Using sodium bisulfite aqueous solution as extractant, the reactive extraction experiments for a heptaldehyde-undecane mixture were carried out. The results show that when the molar ratio between sodium bisulfite and heptaldehyde, the stirring speed, the volume fraction of aqueous phase or the temperature increase, the reactive extraction rate increases. In contrast, larger molar ratio between sodium bisulfite and heptaldehyde, smaller volume fraction of aqueous phase or lower temperature leads to higher equilibrium conversion of heptaldehyde. According to the mass transfer coefficients of the reactive extraction system and the rate constants obtained from the study of intrinsic kinetics, the Ha numbers were estimated. The results show that under the conditions in this paper, 0.3 < Ha < 3, the reactive extraction process was mainly a mixing control process. Since heptaldehyde is soluble in water while sodium bisulfite is not soluble in undecane, the reaction occurs within the film and the main body of the aqueous phase. For the reactive extraction of 1.0 wt % heptaldehyde in undecane using aqueous sodium bisulfite as the extractant, three methods of performing three-stage reactive extraction were investigated. The results showed that equilibrium extraction is highly necessary to ensure the extraction efficiency. Cross-current equilibrium extraction is suitable for situations where high product purity is required; for situations where the separation requirements are not too high, counter-current equilibrium extraction should be preferred.

Experimental investigation and simulation of gas–liquid–liquid reactive extraction process for the production of hydrogen peroxide

Experimental, Numerical Simulation and Genetic Algorithm As a Hybrid Method for the Design of Hydrogen Peroxide Separation Via Non-Dispersive Solvent Extraction

GAS-AGITATED LIQUID AND OXIDATIVE EXTRACTION IN THE ALKYL ANTHRAQUINONE PROCESS FOR THE PREPARATION OF HYDROGEN PEROXIDE

Computational FLuid Dynamics, Artificial Neural Network and Genetic Algorithm As a Hybrid Method for the Design of Hydrogen Peroxide Separation Via Non-Dispersive Solvent Extraction

Process intensification of reactive extraction for hydrogen peroxide production in a rotating packed bed reactor

Development of a Gas–liquid Microstructured System for Oxidation of Hydrogenated 2-Ethyltetrahydroanthraquinone

Coupling Process of Oxidation and Extraction in a Gas–Liquid–Liquid Microdispersion System for H2O2 Synthesis

Process Intensification Of Catalytic Hydrogenation Of Ethylanthraquinone With Gas-Liquid Microdispersion

Research Progress in Reaction Mechanism and Working Solution for Hydrogen Peroxide Production by Anthraquinone Process

Novel Working Solvent for the Production of Hydrogen Peroxide

Continuous photocatalytic preparation of hydrogen peroxide with anthraquinone photosensitizers

Advances in the slurry reactor technology of the anthraquinone process for H 2 O 2 production

Process intensification of H2O2 extraction using gas–liquid–liquid microdispersion system

Microdispersion of Gas or Water in an Anthraquinone Working Solution for the H2O2 Synthesis Process Intensification

Study on the Reactive Extraction Process for Heptaldehyde–Undecane–Sodium Bisulfite Aqueous Solution System

Optimization and reforming for hydrogen peroxide production unit by anthraquinone method

Hydrogen Peroxide Synthesis by Direct Photoreduction of 2-Ethylanthraquinone in Aerated Solutions

Investigating Semibatch Oxidation Reaction of Dimethyl Sulfoxide with Hydrogen Peroxide: Thermal Analysis and Process Optimization

Hydrodynamics of a Fast and Highly Exothermic Liquid-Liquid Oxidation Process with In-Situ Gas Production in Microreacto

Efficient hydrogen peroxide electrosynthesis using anthraquinone covalently bonded CNT on superhydrophobic air breathing cathode

Modeling investigation of mass transfer of gas-liquid-liquid dispersion systems