Control of PM1 by kaolin or limestone during O2/CO2 pulverized coal combustion

Juan Chen,Hong Yao,Ping’an Zhang,Li Xiao,Guangqian Luo,Minghou Xu
DOI: https://doi.org/10.1016/j.proci.2010.06.158
IF: 6.535
2011-01-01
Proceedings of the Combustion Institute
Abstract:In order to reduce the emission of particulate matter with particle size below 1 mu m (PM1) during O-2/CO2 coal combustion, experiments of adding kaolin or limestone to coal were carried out in an electrically heated drop-tube furnace to study their effect on the reduction of PM1. The furnace temperatures were varied from 1173 to 1573 K. Coal combustion in O-2/N-2 at 1373 K was also carried out to compare with the results obtained for oxy-fuel combustion. Two types of lignite with different contents of alkali metals and sulfur were tested. The results show that the emissions of PM1 were reduced effectively by either kaolin or limestone during coal combustion in O-2/CO2, because kaolin has the capability to capture Na and K vapors, whereas limestone reacts with sulfur effectively. The optimum temperature for PM1 reduction by adding kaolin or limestone is 1373 K among the three temperatures tested here. It was also found that, at the furnace temperature of 1373 K, the PM1 reduction extent in O-2/CO2 is higher than that in O-2/N-2. For kaolin, its sintering extent at 1373 K is smaller in O-2/CO2 than in O-2/N-2 at a same O-2 content. For limestone, its high capture capability in O-2/CO2 is most likely caused by a direct sulfation, rather than through initial decomposition followed by the sulfation of lime. (C) 2010 The Combustion Institute. Published by Elsevier Inc. All rights reserved.
What problem does this paper attempt to address?