Abstract:Current dual-constellation GNSS navigation receiver can not fully satisfies the development of navigation industry. The architecture of current Compass and GPS dual-constellation navigation receiver is usually built upon FPGA and float-point DSP. Compared with fix-point DSP and FPGA, float-point DSP works slow and costs much, and it is also difficult to integrate float-point DSP into ASIC or ASSP. So in this paper, we discuss the optimized algorithm and the new implementation that integrate all parts of navigation receiver on one FPGA or ASIC.Our revised algorithm of navigation receiver is introduced first, mainly including acquisition and tracking mechanism. For acquisition module, we divide the whole acquisition process into three units: noise threshold detection, pre-acquisition, acquisition verification. For tracking module, with the help of accurate fix-point simulation, float-point variables are converted to fix-point ones, and rescaling is applied during all process to assure precision.Algorithm only makes sense when it combines with implementation, and the quality of algorithm also should be tested by application. So we also introduce the implementation of navigation receiver baseband algorithm on FPGA platform, including platform architecture, module division, work flow, and some optimization mechanics including resource sharing, process combination and etc. And we simply introduce the measure result and the application of dual-constellation navigation receiver baseband processor.And viterbi decoder for navigation receiver is also discussed. This paper brings forward a revised mechanism of viterbi decoder especially for navigation receiver. We borrow the soft output viterbi algorithm, but do not adopt the algebra ring method, and put forward revised viterbi mechanics. And the optimization is also on shorten-decoding, survival-path combination, butterfly calculation of ACS unit.

FPGA Implementation of C/A Tracking Loop of GPS System

C/A Code of GPS Software Receiver Fast Acquisition Based on FPGA

FPGA Implementation of Non-Parametric Stereo Matching Algorithm

Design of Interface of Astronautic Camera Controller Based on FPGA

Design of GPS base-band processing platform based on FPGA and ARM

Simulation and Analysis of Coarse Acquisition Code Generation Algorithm in GPS System

Research on Signal Tracking Algorithm in Beidou/GPS Pseudo Satellite Positioning System

A Subspace-Based Code Tracking Loop Design for GPS Multi-Antenna Receiver in Multipath Environment

GPS carrier tracking loop design

Design Optimization and Implementation of Carrier Tracking Loop for High Sensitivity GPS Receivers

GPS System Civilian Code Signal Improved Acquisition Algorithm Based on Multi-Sampling Rate and FFT

Design and implement of GPS receiver synchronization module based on FPGA

Analysis and simulation of the GPS-Pseudolite signals

Algorithm Design and Simulation Test for Software GNSS Receiver

Implementation and Performance Assessment of A Vector Tracking Method Based on A Software Gps Receiver

The Optimization of Algorithm and Implementation for Dual-Constellation Navigation Receiver

Simulation and Analysis of GPS Software Receiver

Development and Evaluation of GPS L2C Software Receiver Baseband Signal Processing Module

Implementation of FPGA-Based Acquisition of Weak GPS Signals

The design of GPS high accurate short timing scale based on FPGA

Precision Analysis and Improvement of GPS High Accurate Short Timing Scale Based on FPGA