Abstract:This paper analyzes a recently introduced two-motor five-phase drive system with series connection of stator windings. It has been shown, using physical reasoning, that the introduction of an appropriate phase transposition in the series connection of two machines leads to a complete decoupling of the flux/torque-producing currents of one machine from the flux/torque-producing currents of the second machine. Consequently, independent vector control of the two machines becomes possible while using a single current-controlled five-phase voltage source inverter as the supply. The drive system modeling and control are first elaborated in this paper by taking both machines as induction motors. It is shown, using rigorous mathematical derivations, that the independent control of the two machines results due to the placement of machines in two different subspaces of the five-dimensional space. This is enabled by phase transposition in series connection. The models of the complete drive in the stationary common reference frame and in the rotor-flux-oriented reference frames of the two machines are developed. An associated vector control scheme for the two-motor drive is presented next. The second part of this paper describes an experimental setup used further on to evaluate the dynamic behavior of the two-motor drive. Performance is investigated by extensive experimentation for various transients (acceleration, deceleration, reversing, and disturbance rejection). Excellent decoupling of control of the two machines is achieved. Both the concept of the drive and the approach to modeling and control are thus fully verified experimentally. Finally, the advantages and shortcomings of the series-connected five-phase two-motor drive are discussed, and potential application areas are highlighted.

Driving for Five-Phase Stepper Ultrasonic Motor

Design of Five-Phase Hybrid Stepping Motor Reformative Driver Based on MCU

Design of Five-Phase Hybrid General-Purpose Stepping Motor Driver Based on MCU

Principle And Realization Of A 5-Phase Pm Bearingless Motor Drive

STEPPING CHARACTERISTIC OF ULTRASONIC MOTOR AND ITS STEPPING-POSITIONING CONTROL

A Design of PWM Driving Circuit for Ultrasonic Motor

Design on Driving System of Hybrid Transducer Type Ultrasonic Motor Based on DSP

The Driving of a Single Stator Ultrasonic Motor with Three Degrees of Freedom and Its Position Control

Research on Inertial Drives of Two-degree-of-freedom Ultrasonic Motors

Analysis and Control of Seven-Phase Permanent-Magnet Bearingless Motor with Single Set of Half-Coiled Winding.

Design of a Three-Phase Hybrid Stepping Motor Pulse Subdivision Controller Based on DSP

The Driving Mathematic Model of Spherical Traveling-wave Type Ultrasonic Motor

Design of Subdivided Driving Circuit of Three Phase Stepping Motor

Performance Analysis of Multiphase Induction Motor Drive

Application of frequency/voltage coordinating control strategy to 9-phase hybrid stepping motor driving system

Optimization research of stator with two degree-of-freedom traveling-wave spherical ultrasonic motor

Modeling, Control, and Experimental Investigation of a Five-Phase Series-Connected Two-Motor Drive With Single Inverter Supply

Principle and simulation of a 5-phase bearingless permanent magnet-type synchronous motor

Rotary stepping ultrasonic motor driven by single-phase signal

Design and Analysis on the Parameter Modulation Driving Source of the Ultrasonic Motor

Fault Tolerant Control of a Multiphase Motor with Non-Sinusoidal Source under Open-Phase Conditions