Model of Slag Flow and Heat Transfer at Slag Tap Hole Region of Shell Gasifier

WANG Jian,LIANG Qin-feng,XU Jian-liang,LIU Hai-feng

DOI: https://doi.org/10.3969/j.issn.1005-9954.2012.05.015

2012-01-01

Abstract:In China,there are often big slag blockages at the slag tap hole region of Shell gasifier during long time operation,which is an important threat to the safe,economic and stable operation of industrialization device.A model of flow and heat transfer of molten coal slag at the slag tape hole region of Shell gasifier was proposed to discuss the reason of slag blockage.The thicknesses of solid slag layer and liquid slag layer,and the surface temperature of liquid slag layer were predicted with the proposed model.The results show that there is solid slag layer with certain thickness on the slag screen wall because of slag deposition during gasifier operation.The slag is totally solidified to solid slag at early start-up.When the surface temperature is above the critical temperature,the liquid slag layer appears.The thicknesses of solid slag layer and liquid slag layer both increase with the increase of time until to its stable state.The farther the distance from the slag tap hole is,the thicker the solid and liquid slag layer are and the higher the surface temperature of liquid slag layer is.The lower the slag tap hole temperature and the deposition rate are,the thicker the solid slag layer is and the longer the characteristic time is.