Abstract:Aluminum(Al)/ammonium perchlorate(AP)/hydroxyl-terminated polybutadiene (HTPB) propellant is the most widely used propulsion system currently. Its ignition and combustion processes are fairly complex and need to be better understood. In this study, the thermal decomposition, ignition, and combustion properties of an Al/AP/HTPB propellant were investigated using a thermogravimetry–differential scanning calorimetry and a laser ignition testing system. The morphology and size distribution of the condensed combustion products (CCPs) were analyzed using a laser particle size analyzer and scanning electron microscopy. Results showed that the thermal decomposition process of the propellant consisted of three stages. The first stage (100–430 °C) was a major mass loss stage and exhibited typical features of AP decomposition. The second stage (430–630 °C) was mainly accompanied by the decomposition of remaining HTPB as well as slight oxidation of Al particles. In the third stage, further oxidation of Al particles resulted in a small mass increase. Due to the continuous emission problem, only a few combustion intermediates were identified in the combustion emission spectrum curves. The propellant combustion process could be roughly divided into three stages, and the flame development stage lasted longer than the flame decline stage. As the pressure increased, the propellant ignition delay time decreased and the burning rate increased significantly. The effect of pressure on ignition delay was more pronounced at low pressures. The CCPs consisted of three types. The oxidation of Al particles in the propellant followed the diffusion reaction mechanism. Agglomerates appeared in several different morphologies and had relatively low combustion efficiency under experimental conditions. A 2-D pocket-like structure was observed on the propellant surface.

Thermal Decomposition Characteristics of Double-base Propellant and Multi-nitrate Ester Propellant

Study on the influence of moisture content on thermal stability of propellant.

Exploring the characteristics and thermal behavior of double base propellants based on nitrocellulose and diethylene glycol dinitrate in the presence of ternary-nanothermites containing various oxidizers

Influence of humidity on the heat decomposition speed of single-base propellant

Insight into thermal decomposition behavior of ammonium dinitramide‐based liquid propellant through reactive molecular dynamics simulations

Thermal decomposition and combustion characteristics of Al/AP/HTPB propellant

Effects of Bi-NTO complex on thermal behaviors, nonisothermal reaction kinetics and burning rates of NG/TEGDN/NC propellant

Experimental Study on Thermal and Catalytic Decomposition of a Dual-Mode Ionic Liquid Propellant

Thermal structural damage and thermal decomposition characterization of GAP propellants with nitrate ester plasticizers

Thermal decomposition and kinetics of electrically controlled solid propellant through thermogravimetric analysis

Effects of Thermal Damage on Impact Response Characteristics of High-Energy Propellants

Unraveling the characteristics and pyrolysis mechanism of diethylene glycol dinitrate plasticized nitrocellulose supplemented with organic stabilizers

Experimental Investigation on the Evaporation and Combustion Processes of Ammonium-Dinitramide-Based Liquid Propellant

Thermal Decomposition and Kinetics of Cast Plastic Bonded Explosives Based on NTO and HMX

Molecular dynamics study of the structure and performance of simple and double bases propellants

Reactive molecular dynamics study on the thermal decomposition reaction of a triple-base solid propellant

ReaxFF molecular dynamics simulations on thermal decomposition of RDX-based CMDB propellants

Thermal stability evaluation of black powder, RDX, PETN and TNT

Thermal Behavior and Decomposition Mechanism of Three Nitrate Energetic Materials: TNNP, TNOP and DNHM

Effects of Different Initial Conditions on Combustion Process of Ammonium Dinitramide-Based Energetic Propellant in Straight Nozzle

Analysis of thermal stability for slow burning propellant based on isothermal testing: Self‐accelerating decomposition temperature (SADT) calculation and validation