Abstract:Hydrogen permeation through vanadium/palladium (V/Pd) metal composite membranes is an effective and practical method for separating hydrogen from gas mixtures. In order to gain insight into the correlation between the interfacial structure and hydrogen adsorption/diffusion properties of the catalytic Pd layer bonded to the metal membrane, and then improve the ability of the alloy membrane to purify hydrogen, the first principle based on the density functional theory was used to study the hydrogen adsorption/diffusion behavior at the V/Pd metal composite membrane interface. The results show that because the charge density at the V/Pd interface increases with the V/Pd bonding, the hydrogen atom (H) dissolution energy increases with the approach to the interface, and has the highest dissolution energy near the V/Pd interface (0.567 eV). Hydrogen migration energy barrier calculations show that compared with the maximum energy barrier for horizontal diffusion of H along the V/Pd interface (0.64 eV), the H vertical V/Pd interface energy barrier (0.56 eV) is smaller, thus H tends to migrate vertically V/Pd interface and diffuse from the Pd layer to the V substrate side. As the hydrogen solvation energy of the Pd layer at the V/Pd interface (0.238 eV) is higher than that of the V membrane side (-0.165eV), H will accumulate at the V film side of the interface, which is easy to cause hydrogen embrittlement. Calculations of Pd/Fe doping of the V matrix show that compared with the undoped energy barrier (0.56 eV), Pd/Fe doping can significantly reduce the maximum energy barrier (0.45/0.54 eV) in the diffusion path of the interface, which is favorable for hydrogen permeation and diffusion. And the doped interface can inhibit the interdiffusion of V and catalytic Pd layers, which improves the structural stability of the composite film.

Study of N Value and Α/β Palladium Hydride Phase Transition Within the Ultra-Thin Palladium Composite Membrane

Hydrogen permeation in a palladium membrane tube: Impacts of outlet and vacuum degree

INVESTIGATION OF GAS TRANSMISSION CHARACTERISTICS OF THIN-FILM MEMBRANE MATERIALS BASED ON PALLADIUM ALLOYS

Determining flux-limiting mechanism of hydrogen permeation through palladium membrane by n value

Influence of external mass transfer and support resistances for hydrogen permeation through composite palladium membranes

Microstructural Investigation and On-Site Repair of Thin Pd-Ag Alloy Membranes

Thermal Degradation Behavior of Hydrogen Permeability of Pd-Coated V-Alloy Membrane for Hydrogen Separation and Purification

First-principles evaluation of Pd–Pt–Ag and Pd–Pt–Au ternary alloys as high performance membranes for hydrogen separation

Palladium membranes supported on porous ceramics prepared by chemical vapor deposition

Preparation of a zeolite-palladium composite membrane for hydrogen separation: Influence of zeolite film on membrane stability

Preparation and characterization of NiP amorphous alloy/ceramic composite membrane

First principles study of vanadium/palladium interface interactions and their hydrogen absorption properties

Realizing Stable High Hydrogen Permeation Flux Through BaCo0.4Fe0.4Zr0.1Y0.1O3-δ Membrane Using a Thin Pd Film Protection Strategy

Studies on the Preparation of Pd/Alumina/Porous Stainless Steel Membranes for Hydrogen Separation

Enhancement for hydrogen transport properties by tailoring lattice matching in V-Pd-Fe ternary alloy membrane

Hydrogen Permeation Performance of a Pd-Ag Membrane Reactor in Dimethyl Ether Steam Reforming System

Preparation of continuous NH2–MIL-53 membrane on ammoniated polyvinylidene fluoride hollow fiber for efficient H2 purification

Thin robust Pd membranes for low-temperature application

Design of hydrogen separatinwg Nb-Ti-Fe membranes with high permeability and low cost

Thermal Stability, Hydrogen Adsorption and Separation Performance of Ni-based Amorphous Alloy Membranes

Palladium-copper membrane prepared by electroless plating for hydrogen separation at low temperature