Abstract:In this study, a dynamic constitutive model for woven-carbon-fiber-reinforced plastics (CFRP) is formulated by combining dynamic tensile test data and fitting curves and incorporating variation rules established for the modulus of elasticity, strength, and fracture strain with respect to the strain rate. The dynamic constitutive model is then implemented with finite element software. The accuracy and applicability of the dynamic constitutive model are evaluated by comparing the numerically predicted load–displacement curves and strain distributions with the test data. The stress distribution, failure factor, modulus, and strength of the material under dynamic tension are also explored. The results show that the response simulated with the dynamic constitutive model is in good agreement with the experimental results. The strain is uniformly distributed during the elastic phase compared with the DIC strain field. Subsequently, it becomes nonuniform when stress exceeds 600 MPa. Then, the brittle fracture occurs. With the increase in the strain rate, the input modulus decreased, and the tensile strength increased. When the displacement was 0.13 mm, the simulation model was damaged at a low strain rate, and the stress value was 837.8 MPa. When it reached the high strain rate of 800 s−1, no failure occurred, and the maximum stress value was 432.5 MPa. For the same specimen, the strain rate was the smallest on both clamped ends, and the modulus and strength were large at the ends and small in the middle. The fitting curve derived from the test data was completely input into the dynamic constitutive model to better capture the dynamic change in the material properties.

Predicting Mechanical Constitutive Relationship of Polypropylene

Mechanical Behaviors of Copolymer Elastomers: Experimental Characterization and Constitutive Modelling

Comparison Among Three Different Approaches to Dynamic Damage Measurement for Polymer Blends

Rate-dependent Constitutive Model of Poly(ethylene Terephthalate) for Dynamic Analysis

A Phenomenological Thermal-Mechanical Viscoelastic Constitutive Modeling For Polypropylene Wood Composites

Experimental and Modelling of Constitutive Equation of Polycarbonate Material

Dynamic Tensile Behavior of Polyamide 6 at Different Strain Rates: Experiments and Constitutive Model

Numerical Prediction of Elastic-Plastic Constitutional Behaviour of Thermoplastic Composites

Development of an Analytical Model for Predicting the Tensile Modulus of Complex Polypropylene Compounds

Compressive Properties and Constitutive Model of Semicrystalline Polyethylene.

Experimental Study of Yield Surface in Polypropylene Considering Rate Effect: Stress Path Dependence

Strain Rate-Dependent Hyperbolic Constitutive Model for Tensile Behavior of PE100 Pipe Material

Effect of Material Anisotropy on the Mechanical Response of Automotive Steel under High Strain Rates

A constitutive model for poly-methyl-methacrylate over a wide range of strain rates and temperatures

A Dynamic Constitutive Model and Simulation of Braided CFRP under High-Speed Tensile Loading

Rate-Dependent Behavior And Constitutive Model Of Dp600 Steel At Strain Rate From 10(-4) To 10(3) S(-1)

Parameter Determination and Model Modification of Sherwood-Frost Constitutive Model

A viscoelastoplastic constitutive model of semi-crystalline polymers under dynamic compressive loading: Application to PE and PA66

Dynamic compressive behavior and constitutive model of polyamide-6 at different temperatures and strain rates

Rate-dependent behavior and constitutive model of DP600 steel at strain rate from 10−4 to 103s−1

A constitutive model of the compressive mechanical properties of ultra high molecular weight polyethylene (UHMWPE) at different temperatures and different strain rates