Abstract:High-temperature alkali-metal heat pipes are passive heat transfer devices, where the capillary pressure created by the menisci in the wick pumps the condensed fluid back to the evaporator. Thus, the heat pipe heat transfer capacity is limited by the maximum capillary pressure at high heat fluxes. This work presents a two-dimensional heat and mass transfer model for alkali metal heat pipes. In addition to the traditional wall heat conduction model, the model also incorporates gas-liquid flow heat transfer and capillary structure models, enabling the model to simulate both steady-state operation and transient capillary limit processes. The predictions of the model agreed well with experimental data. The predicted critical heat flux temperature has an error of less than 20 & DEG;C and a relative error of 6%. The predicted transient sequences are consistent with the measurements. The model shows that capillary limit is affected by inclination angle, heat flux, and wick structure. For inclinations, the critical heat flux at the capillary limit is linearly related to the inclination angle with the predicted temperature rising 2-10 & DEG;C/s during the early stage of the capillary limit critical heat flux condition. The evaporator temperature oscillates before the capillary limit with positive inclinations. For heat fluxes, increasing the heat flux by 17% increases the temperature increase rate 10 fold with a longer dryout length. The evaporator exhibits hysteresis after the capillary limit due to partial dryout of evaporator. For wick structures, reducing the mesh screen pitch from 80 & mu;m to 15 & mu;m reduces the critical heat flux to 10% of the CHF at 80 & mu;m. This model can accurately predict the heat pipe temperature variations at the capillary limit and can explain the physical mechanisms for the dryout oscillations and recovery hysteresis at the capillary limit. Thus, the measurements and model provide analytical guidelines for designing heat pipe cooling systems.

Evaporation and Condensation Heat Transfer Characteristics of Heat Pipe with Axially Swallow-Tailed Microgrooves

Heat Transfer Capacity Optimization Design of Microgroove and Microcolumn in an Ultra-Thin Flat Heat Pipe

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Numerical exploration of optimal microgroove shape in loop-heat-pipe evaporator

Three-Dimensional Numerical Study on the Flow and Heat Transfer in Wick of Loop Heat Pipe

Capillary Limit of a Sodium Screen-Wick Heat Pipe

Fluid flow and heat transfer model for high-speed rotating heat pipes

Numerical investigation on transient and steady phase change heat transfer in the evaporator of a loop heat pipe

Numerical simulation of condensation heat transfer characteristics of R134a at high vapor velocity under different angles

Mesoscopic numerical study of the startup characteristics of grooved heat pipe under high heat flux

Transient Analysis of A Cylindrical Heat Pipe Considering Different Wick Structures

Investigation on Microheat Pipe Array with Arteries

An Improved Model of the Heat Pipe Based on the Network Method Applied on a Heat Pipe Cooled Reactor

Capillary Evaporating Film Model for a Screen-Wick Heat Pipe

Investigation of Thermal Characteristics and Two-Phase Flows of a Star-Shape Thin Heat Pipe

Corner Flow Characteristics in a Silicon-Based Ultra-Thin Flat-Grooved Heat Pipe with Double-End Cooling

Influence of the liquid plug on the heat transfer performance of the ultra-thin flat heat pipe

Experimental comparison and numerical study of flow and heat transfer characteristics of the pipe rows in heat pipe heat exchanger

Analysis of Flow and Heat Transfer in Evaporator Porous Wicking Structure of A Flat Heat Pipe

Effect of the Heat Pipe Adiabatic Region

Thermal performance of a cylindrical shell-like thin networked pulsating heat pipe