Abstract:The stack is a crucial component of the thermoacoustic heat engine, influencing its capacity to generate stable pressure amplitude and enhance efficiency. Utilizing the discontinuous Galerkin (DG) method, fully compressible Navier-Stokes equations were solved to simulate the energy exchange between the stack and surrounding air under various conditions. (1) Simulations were conducted under different stack wall boundary conditions, including linear temperature distribution wall, isothermal wall, and adiabatic wall. The work performed by 1 kg of gas at a specific position during one cycle was defined as local energy density to analyze the effect of different stack spacing, stack length and stack thickness. (2) Too small a stack spacing causes the inability to generate pressure amplitude. Increasing the stack spacing continuously enhances the generated pressure amplitude, with the energy density distribution near the hot heat exchanger becoming more significant. As the stack spacing continues to increase, the energy density decreases at positions farther from the wall, leading to a reduction in pressure amplitude. The generated acoustic streaming intensity diminishes faster with the continuous increase in stack spacing. (3) A smaller stack length results in reduced viscous dissipation at the wall, leading to a larger generated pressure amplitude. However, shorter stack lengths cause increased gas oscillation displacement, resulting in lower energy density concentrate around the stack. This raises the load on the two heat exchangers, consequently reducing the overall efficiency. (4) The pressure amplitude decreases with the increase in stack thickness. The vortex intensity at the gap between the hot heat exchanger and the stack increases with the stack thickness, leading to higher viscous losses for the fluid passing through this region. Consequently, the performance of the thermoacoustic engine declines. These findings provide valuable guidance for the design of thermoacoustic engines.

A Comparison of Simulation and Experiment on Stack Effect in Long Vertical Shaft

Study on Numerical Simulation of Hydraulic Regime of Single Stack Drainage System

Experimental study on the generation mechanism of stack effect

Numerical Simulation of the Performance of the Sc-89 Jet Impact System

Computational fluid dynamics numerical simulation of flue gas emission from stack and tower integration system of coal-fired power plant

Effect of Stacking Conditions on Performance of A Centrifugal Pump

Large Eddy Simulation of stack effect on natural smoke exhausting effect in urban road tunnel fires

Numerical Simulation of Mixing Capability in Coal-Slurry Mixing Tank

An analytical model of stack ventilation in a shaft with controllable air volume

Influence of longitudinal wind on natural ventilation with vertical shaft in a road tunnel fire

A Simple Flame Plume Model Induced By Stack Effect

Numerical Simulation and Experimental Study of Two-Phase Flow in a Vertical Pipe

One-Dimensional Smoke Movement In Vertical Open Shafts At Steady State: Theoretical Prediction And Experimental Verification

Evaluation of Stack Ventilation in a Large Space Using Zonal Simulation and a Reduced-Scale Model Experiment with Particle Image Velocimetry

Scale Model and Numerical Validation of Smoke Movement in Long-Narrow Underground Fires

Assessment Of Performance Of Turbulence Models Of Cfx In Predicting Supercritical Water Heat Transfer In A Vertical Tube

Theoretical and Numerical Study of Smoke Acceleration Effect in the U Shaped Shaft of a High-Rise Building

Portraying the Countercurrent Flow on Packings by Three‐Dimensional Computational Fluid Dynamics Simulations

Simulation study on effects of longitudinal ventilation on smoke exhausting performance of tunnel shafts

Full-scale Fire Experiments and Simulation of Tunnel with Vertical Shafts

Numerical Simulation Investigating the Influence of Varied Stack Parameters on the Energy Conversion in Thermoacoustic Engines