Abstract:<p>The study focuses on the mass flow rate of the buoyancy-driven gases exhausted from the shaft in naturally ventilated urban road tunnel fires. Theoretical analyses and numerical simulations are performed. The model to predict the mass flow rate of the incoming smoke exhausted by the nearest shaft is developed by considering that the smoke is exhausted along the four sides of the shaft separately. Based on the heat balance between the incoming smoke exhausted and the total gas flow exhausted, the model to estimate the total mass flow rate exhausted from the shaft (both smoke and entrained air) is also established. Meanwhile, a series of numerical simulation in a naturally ventilated tunnel considering the heat release rate (HRR), the shaft height, shaft length and width, shaft location was carried out. The simulation results show that the shaft height has a limited contribution to the mass flow rate of the incoming smoke exhausted while a larger shaft cross-sectional area shows a favorable performance in exhausting the smoke. Further, the air entrainment into the shaft increases with both the shaft height and shaft cross-sectional area. Comparisons of the mass flow rates of the incoming smoke and the total mass flow rates exhausted between simple calculations and simulations are made, showing that the simple models perform well. Further, it is found that there exist two regimes for the total mass flow rate corresponding to different smoke modes in the shaft (complete plug-holing, plug-holing and without plug-holing), which is caused by the different driven forces in the shaft. The outcomes of this work could provide some guidance for the design of vertical shaft and smoke control in naturally ventilated tunnel in urban area.</p>

A theoretical model to predict plume rise in shaft generated by growing compartment fire

Numerical Study on Plume Bifurcation in Longitudinally Ventilated Tunnel Fires

One-Dimensional Smoke Movement In Vertical Open Shafts At Steady State: Theoretical Prediction And Experimental Verification

A modified turbulent mixing model with the consideration of heat transfer between hot buoyant plume and sidewalls in a closed stairwell

Modelling the Maximum Ceiling Temperature with Bifurcated Plume in Tunnel Fires

A 3D Mathematical Tunnel Fire Model with Consideration of Combustion

Thermal Buoyant Smoke Back-Layering Length in a Naturally Ventilated Tunnel with Vertical Shafts

Plug-holing height and complete plug-holing phenomenon in naturally ventilated tunnel fires with vertical shaft

Investigation on the Critical Shaft Height of Plug-Holing in the Natural Ventilated Tunnel Fire

Maximum Temperature of Smoke Beneath Ceiling in Tunnel Fire with Vertical Shafts

Modelling and experimental investigation of critical velocity and driving force for preventing smoke backlayering in a branched tunnel fire

Theoretical and numerical study on mass flow rates of smoke exhausted from short vertical shafts in naturally ventilated urban road tunnel fires

Effects of Fire Source Position on Smoke Extraction Efficiency by Natural Ventilation Through a Board-Coupled Shaft During Tunnel Fires

Numerical investigation of the temperature characteristics beneath the ceiling driven by a strong plume in a longitudinal ventilated tunnel

A Study on the Behavior Characteristics of Air Supply during Tunnel Fires under Natural Ventilation with Multiple Vertical Shafts

Experimental study on the generation mechanism of stack effect

Smoke back-layering flow length in longitudinal ventilated tunnel fires with vertical shaft in the upstream

Studies on Buoyancy-Driven Back-Layering Flow in Tunnel Fires

Experimental Study of the Influences of Board Size and Position on Smoke Extraction Efficiency by Natural Ventilation Through a Board-Coupled Shaft During Tunnel Fires

Theoretical and Numerical Study of Smoke Acceleration Effect in the U Shaped Shaft of a High-Rise Building

Comparison of Natural Convection with Fire Plumes in Typical Shafts