Abstract:This paper presents the results from an experimental investigation on the flow of hot gases induced by pressure and buoyancy in vertical shafts. This flow circumstance simulates the propagation of smoke and other combustion products in vertical elevator shafts due to fire in high-rise, multistoried, buildings. The effect of natural and forced ventilation, occurring through shaft openings or vents, on the spread of smoke and hot gases is of particular interest with respect to the development of hazardous conditions in the building. Different configurations are investigated, such as natural and forced ventilation at the top or the bottom of the vertical shaft. The inflow conditions for the hot gases, at a vertical opening near the base of the shaft, are varied and characterized in terms of the inlet Grashof and Reynolds numbers. Extensive temperature measurements are taken within the shaft. These data are used to investigate the steady state thermal field that arises for various scenarios. These results may then form the basis for developing appropriate approaches for smoke mitigation in high-rise building fires. Flow visualization, using smoke and a Schlieren system, is also used to study the flow characteristics in the shaft and near the hot gas inlet. The results obtained indicate that a wall plume arises in several cases and a relatively well-mixed flow in others. A strong wall flow arises at high Grashof numbers and low Reynolds numbers, while increasing Reynolds numbers leads to greater mixing in the shaft. The resulting flow and its effect on the spread of hot gases and temperature decay are investigated for different shaft configurations and inlet conditions. It is found that the best smoke or hot gas removal and lowest shaft temperatures occur with natural ventilation at the top and forced ventilation up from the shaft bottom. It is also shown that forced downward flow at the top can be used to arrest smoke spread, as well as to minimize the effects of the fire.

Comparison of Natural Convection with Fire Plumes in Typical Shafts

Comparison of Fire Induced and Heat Driven Flows in Vertical Shafts

Natural convection heat transfer in concentric annuli with nanofluids

Numerical Study on Plume Bifurcation in Longitudinally Ventilated Tunnel Fires

Effects of vertical shaft arrangement on natural ventilation performance during tunnel fires

3D Numerical Simulation of Smoke Flow in Long Tunnel Fires

Numerical study of the fire-smoke temperature law in the shaft of a high-rise building under the chimney effect in winter

A theoretical model to predict plume rise in shaft generated by growing compartment fire

One-Dimensional Smoke Movement In Vertical Open Shafts At Steady State: Theoretical Prediction And Experimental Verification

Investigation on the Critical Shaft Height of Plug-Holing in the Natural Ventilated Tunnel Fire

Experimental Study of Air Entrainment Mode with Natural Ventilation Using Shafts in Road Tunnel Fires

Full-scale Fire Experiments and Simulation of Tunnel with Vertical Shafts

Theoretical and numerical study on mass flow rates of smoke exhausted from short vertical shafts in naturally ventilated urban road tunnel fires

Experimental Study on Tunnel Fire Behaviors under Natural Ventilation Using Shafts

Natural Convection Heat Transfer and Fluid Flow in a Thermal Chimney with Multiple Horizontally-Aligned Cylinders

Numerical study of natural ventilation in urban shallow tunnels: Impact of shaft cross section

Flow of hot gases in vertical shafts with natural and forced ventilation

Influence of Different Longitudinal Wind on Natural Ventilation Efficiency with Vertical Shaft Under Different Fires in Tunnel

Theoretical and Numerical Study of Smoke Acceleration Effect in the U Shaped Shaft of a High-Rise Building

Influence of longitudinal wind on natural ventilation with vertical shaft in a road tunnel fire

Thermal Buoyant Smoke Back-Layering Length in a Naturally Ventilated Tunnel with Vertical Shafts