Abstract:In situ Sr isotope analysis of geological materials by laser ablation multiple collector-inductively coupled plasma mass spectrometry (LA-MC-ICP-MS) is a powerful tracer technique for tracking magmatic source components and geological processes. However, the accuracy and precision of the 87Sr/86Sr ratio are limited in the analysis of natural minerals because of the low-Sr concentration, the isobaric interference or small grains with complex textural contexts, especially for transparent minerals such as feldspars. In this study, analytical results demonstrated that ablation rates in fs laser ablation were consistent for various samples (0.08–0.11μm per pulse), but those in ns laser ablation were obviously material properties-dependent, such as the rates of 0.026μm per pulse and 0.144μm per pulse for feldspar and pyrite, respectively. In addition, at similar energy fluences, the sensitivities of Sr in feldspars analyzed by the fs laser were 3.4 times higher than those analyzed by the ns laser due to the higher ablation efficiency of the fs pulse. These advantages of the fs laser not only offer the benefit of eliminating or weakening the matrix effect during the laser ablation processes but also help to improve the analytical precision for transparent minerals. We also demonstrated that the isobaric interferences of calcium dimers and argides (CaAr++CaCa+) and Kr+ were dramatically reduced by factors of 6.5–11.7 and 5–12.5 in the presence of 6–12mlmin−1N2, respectively. Furthermore, with the addition of N2 (12mlmin−1), the sensitivity of Rb was inhibited, resulting in a decrease of 1.47 times in Rb/Sr signal ratios. Due to the effect of suppressing interferences by adding N2, both the stability and accuracy of the 87Sr/86Sr and 84Sr/86Sr ratios show improvement, especially for the Rb-rich feldspars.

Isotope Determination of Lead and Bismuth by Pulsed Laser Evaporation and Resonance Ionization Time-of-flight Mass Spectrometry

Comparison of the detection characteristics of trace species using laser-induced breakdown spectroscopy and laser breakdown time-of-flight mass spectrometry

Improved in situ Sr isotopic analysis by a 257 nm femtosecond laser in combination with the addition of nitrogen for geological minerals

Determination of Isotopic Ratio by Multi-collector Double-focusing Inductively Coupled Plasma Mass Spectrometry

Sensitive Elemental Analysis of Aqueous Colloids by Laser-Induced Plasma Spectroscopy

Laser Spectroscopic Measurement of Helium Isotope Ratios

Technique of Lutetium Isotopic Analysis by Laser Resonance Ionization Mass Spectrometry

Expressing Lead Isotopic Compositions by Fractional Abundances for Environmental Source Apportionment.

Measurement of Lithium Isotope Ratio Using Tunable External Cavity Diode Laser

Laser optogalvanic spectroscopy of lead lines - isotope shifts and hyperfine structure studies

Low-cost and sensitive method for Pb isotope determination using a novel β-Si3N4 emitter by thermal ionization mass spectrometry

AN EXPERIMENTAL INVESTIGATION ON LEAD ISOTOPIC FRACTIONATION DURING METALLURGICAL PROCESSES*

Isotopes Separation Method using Physical Vapor Deposition Technique

Progress of laser ionization mass spectrometry for elemental analysis — A review of the past decade

Charge state distribution analysis of Al and Pb ions from the laser ion source at IMP

Optimization of analytical conditions for precise and accurate isotope analyses of Li, Mg, Fe, Cu, and Zn by MC-ICPMS

Heavy metals in the atmosphere determination by double-pulse laser induced breakdown spectroscopy

Application of Laser Ionization Mass Spectrometry for Measurement of Uranium Isotope Ratio in Nuclear Forensics and Nuclear Safeguards

Detection of 238Pu at picogram quantities by laser resonance ionization mass spectrometry

Semi-Quantitative Analysis of Geological Samples Using Laser Plasma Time-Of-Flight Mass Spectrometry

Elemental Imaging Method Based on a Dielectric Barrier Discharge Probe Coupled with Inductively Coupled Plasma Mass Spectrometry