Abstract:Flow characteristics of turbulent impinging jets issuing, respectively, from a rectangular and a square nozzles have been investigated numerically through the solution of three-dimensional Navier-Strokes equations in steady state. Two geometries with two nozzle-to-plate spacings of four and eight times of hydraulic diameters of the jet pipes, and two Reynolds numbers of 20000 and 30000 have been considered with fully developed inlet boundary conditions. An RNG based k–ε turbulence model and a deferred correction QUICK scheme in conjunction with the wall function method have been applied to the prediction of the flow fields within semi-confined spaces. A common feature revealed by the computational results is the presence of a toroidal recirculation zone around the jet. An adverse pressure gradient is found at the impingement surface downstream the stagnation point. Boundary layer separation will occur if the gradient is strong enough, and the separation manifests itself as a secondary recirculation zone at the surface. In addition, three-dimensional simulations reveal the existence of two and four pronounced streamwise velocity off-center peaks at the cross-planes near to the impingement plate, respectively, in the rectangular and square impinging jet flows. These peaks are found forming at the horizontal planes where the wall jets start forming accompanied by two or four pairs of counter-rotating vortex rings. It is believed that the formation of the off-center velocity peaks is due to the vorticity diffusion along the wall jet as the jet impinges on the target plate.

Two Dimensional Simulation Of Velocity Field Of Two-Phase Flow For Gas And Solid In The Abrasive Air Jet Nozzle

Simulation of Velocity Field of Two-Phase Flow for Gas and Liquid in the Abrasive Water Jet Nozzle

Research on motion characteristics of gas-solid jet flow

Numerical Simulation of Gas-Droplet Two-Phase Flow Field in Nozzle

Numerical Simulation of the Gas-Solid Flow Around the Valve of Pneumatic Conveying System

Three-Dimensional Numerical Simulation of Air Exhausted from Submerged Nozzles

The Research on High-Speed Gas Jet of Rocket Nozzle Underwater

Optimization of Abrasive Water Jet Nozzle Based on Numerical Simulation

Track Calculation and Numerical Simulation on Particles in High Pressure Abrasive Water Jet Nozzle

Numerical Simulation of Gas-Particle Two-Phase Flow in SRM Nozzle by the Method of CFD-DSMC

A study of abrasive waterjet characteristics by CFD simulation

Research on Multiphase Flow and Nozzle Wear in a High-Pressure Abrasive Water Jet Cutting Head

Numerical Simulation and Experimental Study of Two-Phase Flow in a Vertical Pipe

Numerical Simulation Analysis of Four‐stage Variable Diameter Pipe for Solid–liquid Two‐phase Abrasive Flow

Numerical Simulation Studies on Multiphase Flow in High Temperature Wind Tunnel Contractions and Experimental Sections

Three-Dimensional Simulation of Turbulent Rectangular and Square Impinging Jet Flows

Two-way coupled CFD-DEM model of a pre-mixed abrasive water jet and its application to the investigation of abrasive motion characteristics

Simulation and Analysis of High-pressure Nozzle Geometric Parameters on the Property of Efflux Flow Field

Numerical and experimental investigation of flow in swirling nozzle

Numerical simulation of the dimensional transformation of atomization in a supersonic aerodynamic atomization dust-removing nozzle based on transonic speed compressible flow

Numerical study on coupled flow characteristics of a gas-solid two-phase jet in a supersonic crossflow