Early Smoldering Characteristics of Cotton Block and Correlative Compound Aspirating Smoke Detection

Jin-jun WANG,Yi ZENG,Wei YUAN,Ran TU,Yi-fei SHI,Jun FANG,Yong-ming ZHANG
DOI: https://doi.org/10.3969/j.issn.1009-6094.2012.02.046
2012-01-01
Applied Mechanics and Materials
Abstract:By setting the background of study as fire protection of cotton warehouse,the goals of this research are to experimentally investigate the smoldering characteristics of cotton blocks at the very early stage,to compare the change of CO concentration which is a major smoldering product and the response of conventional aspirating smoke detector and finally to provide engineering suggestions on early fire detection in a typical cotton warehouse.Two different series of experiments were designed and conducted respectively.One of them was the study of smoldering characteristics of cotton blocks with different sizes conducted in an ISO standardized combustion room.The smoldering rate,ionization smoke concentration on the ceiling and image information were recorded and analyzed by electronic balance,measurement ionization chamber(MIC) and CCD camera,respectively.It was observed that both horizontal and vertical smoldering spreads occurred if the cotton block was ignited from the top.After ignition,the smoldering first spread over the horizontal surface of cotton block at a relatively slow rate;when the burning area has reached to some extent,it spread vertically at a significant faster rate.Another experiment was carried out to study the responses of fire detectors to typical smoke or gas signal.It has shown that the CO response time of MRU was 1 2.3 times faster than the aspirating detector due to different air entry points.The reason of better transportation of CO in the aspirating pipelines lies on a relatively low smoldering temperature which causes weak turbulent buoyancy of smoldering plume.Furthermore,the density of CO is much smaller than that of smoke particle.The study suggested that a combined technology of aspirating smoke detection and CO gas detection should be adopted in large space especially in a cotton warehouse.The fire detection sensitivity at early stage of smoldering could be greatly improved.Besides,lower false and failure rate of fire alarm could be expected as well.
What problem does this paper attempt to address?