Effect of Density on the Smoldering Characteristics of Cotton Bales Ignited Internally

Mingming He,Long Ding,Longxing Yu,Jie Ji

DOI: https://doi.org/10.1016/j.proci.2020.06.219

IF: 6.535

2021-01-01

Proceedings of the Combustion Institute

Abstract:The cotton fire often occurs during storage, and it is valuable to reveal the combustion characteristics of cotton bales. However, most of the previous studies only focused on the combustion phenomenon of cotton bales after ignited externally. In fact, during the storage of cotton, the fire often originated from inside of a cotton bale, resulted from the sparks introduced into the cotton bale by the ginning machinery and the heat generated due to hygroscopic property. Therefore, an experimental study was conducted to investigate the effect of density on the smoldering characteristics of cotton bales ignited internally. In this study, the cotton densities of experimental study were 50, 60, 70, 80, 90, 100, 110 and 120 kg/m(3). The change rules of the smoldering spread rate in external horizontal, internal horizontal, and internal vertical during the combustion process as well as the mass loss of the cotton bales with these densities were studied, and the spreading processes of the smoldering in these cotton bales were also determined. The experimental results show that due to differences in the amount of oxygen and heat flux, an increase in density leads to a decrease in the spread rates in external horizontal, internal horizontal and internal vertical. With the increase in density, the porosity decreases and the amount of air is reduced, so the spread rate gradually decreases. However, the mass loss rate, i.e. the amount of burning cotton per unit time, increases with density. And, as the overall amount of cotton increases with density, the burning time also increases. (C) 2020 The Combustion Institute. Published by Elsevier Inc. All rights reserved.