Abstract:An elastoplastic solution with higher-order terms for cracks in materials exhibiting pressure-sensitive yielding and plastic volumetric deformation is presented in this paper. Two-term expansions of the plane strain and plane stress solutions for a crack in a homogeneous material are obtained. It is shown that a variable-separable solution form under plane strain conditions exists only for weakly pressure-sensitive materials and the limit values of the pressure-sensitivity factor depend on the strain-hardening exponent. The second-order plane strain terms have to be solved as an eigenvalue problem and the elastic terms enter the second-order solutions only when the material has substantial strain-hardening. It follows that the second stress amplitude factor must be determined by the applied load. The values of the second exponents in the stress expansion are slightly larger than zero for most hardening materials and behave as an increasing function of the pressure-sensitivity factor. The finite element computations confirm that the second-order terms under plane strain conditions will increase dominance of the asymptotic solution remarkably. The plane stress analysis shows that the amplitudes of both leading-order and second-order solution are determined by the J-integral for most pressure-sensitive dilatant materials. The variable-separable asymptotic solution exists for all available values of the pressure-sensitivity factor. Because of rapid changes in leading-order terms of the stress component 295-1 at ϑ≥160° the second-order solution will not significantly improve the prediction of the asymptotic solution in the whole tip field. Numerical results based on the incremental theory of plasticity show that the asymptotic solution characterizes the near-tip fields. Finite strains dominate in the region 295-2 under plane strain conditions. The two-parameter boundary layer formulation with different T-stresses predicts that the higher-order terms are only weakly dependent on the distance to the crack tip and vary significantly with ϑ in the forward sector.

On the Interface Crack Between Two Elastic Layers Under General Edge Loads

T-Stress and Stress Intensities for the Interface Cracks in Some Specimen-Relevant Geometries

Interaction between rectangular cracks embedded in infinite medium

Logarithmic Singular Stress Field in an Interface Edge Consisting of Two Bonded Dissimilar Materials Subjected to a Concentrated Couple on Apex

A three-dimensional formula for determining stress intensity factors in finite element analysis of cracked bodies

Investigation of Stress Intensity Factors for an Interface Crack in Multi-Interface Materials Using an Interaction Integral Method

Elastic Fracture Mechanics Concepts for Interfacial Cracks

Three-dimensional Stress and Stress Intensity for Tensioned Flat Plates with Edge Cracks

Interaction Between an Edge Dislocation and a Bridged Crack with Surface Elasticity

Interfacial crack-tip field in anisotropic elastic solids

The compressive stress effect on fatigue crack growth under tension–compression loading

Macrostress field of crack in finite body under compression-shear condition and its energy of propagation

Solutions of Stress Intensity Factors of Subsurface Cracks

Finite deformation near a crack tip terminated at an interface between two neo-Hookean sheets

Stress analysis of an elastic semi-infinite plate containing internal crack

A Hybrid Finite-Element Analysis of Interface Cracks

Green’s Function for T-stress of Semi-Infinite Plane Crack

Stress intensity factor analysis of interface cracks using X‐FEM

The Yoffe-type moving tubular interface crack in a hollow composite cylinder with finite length

Quantification of constraint effects in elastic-plastic crack front fields

Elastoplastic Crack Analysis for Pressure-Sensitive Dilatant Materials ? Part I: Higher-order Solutions and Two-Parameter Characterization