Elastoplastic Crack Analysis for Pressure-Sensitive Dilatant Materials ? Part I: Higher-order Solutions and Two-Parameter Characterization

Huang Yuan,Guoyu Lin

DOI: https://doi.org/10.1007/bf00012395

IF: 2.635

1993-01-01

International Journal of Fracture

Abstract:An elastoplastic solution with higher-order terms for cracks in materials exhibiting pressure-sensitive yielding and plastic volumetric deformation is presented in this paper. Two-term expansions of the plane strain and plane stress solutions for a crack in a homogeneous material are obtained. It is shown that a variable-separable solution form under plane strain conditions exists only for weakly pressure-sensitive materials and the limit values of the pressure-sensitivity factor depend on the strain-hardening exponent. The second-order plane strain terms have to be solved as an eigenvalue problem and the elastic terms enter the second-order solutions only when the material has substantial strain-hardening. It follows that the second stress amplitude factor must be determined by the applied load. The values of the second exponents in the stress expansion are slightly larger than zero for most hardening materials and behave as an increasing function of the pressure-sensitivity factor. The finite element computations confirm that the second-order terms under plane strain conditions will increase dominance of the asymptotic solution remarkably. The plane stress analysis shows that the amplitudes of both leading-order and second-order solution are determined by the J-integral for most pressure-sensitive dilatant materials. The variable-separable asymptotic solution exists for all available values of the pressure-sensitivity factor. Because of rapid changes in leading-order terms of the stress component 295-1 at ϑ≥160° the second-order solution will not significantly improve the prediction of the asymptotic solution in the whole tip field. Numerical results based on the incremental theory of plasticity show that the asymptotic solution characterizes the near-tip fields. Finite strains dominate in the region 295-2 under plane strain conditions. The two-parameter boundary layer formulation with different T-stresses predicts that the higher-order terms are only weakly dependent on the distance to the crack tip and vary significantly with ϑ in the forward sector.