Abstract:Heavy metals accumulated in slurry of dual alkali flue gas desulfurization (FGD) present a significant catalysis to SO3(2-) oxidation, resulting in a waste of effective components for desulfurization. Na2S was adopted to precipitate heavy metal ions in FGD slurry, and the oxidation rate of SO3(2-) was obtained under different concentrations of heavy metal ions, to reveal the inhibition effect of Na2S on SO3(2-) oxidation catalyzed by heavy metal ions. Mn2+ showed a remarkable catalysis to SO3(-2) oxidation, as the initial oxidation rate of SO3(2-) was tripled to 0.65 mmol/(L x min) by adding 1.0 mmol/L Mn2+ into the slurry. SO3(2-) was catalytically oxidized rapidly with the reaction order 0.169 of Mn2+ within first 60 minutes, so it is of great importance to control the concentration of Mn2+ to inhibit SO3(2-) oxidation. At initial pH value of 6.50-8.50, Na2S removed heavy metal ions effectively from FGD slurry. Higher pH value favored the removal of heavy metal ions. The removal efficiencies of Mn2+, Zn2+, Ni2+ and Cd2+ were 91.0%, 88.1%, 85.5%, and above 99.9% respectively under the conditions of initial pH value 8.50 and Na2S dosage 240.0 mg/L. Mn2+ could be used as an indicator for the concentration of the heavy metal ions in the slurry. As the Mn2+ concentration decreased from 1.0 mmol/L to 5.0 x 10(-3) mmol/L by adding Na2S, the initial oxidation rate of SO3(2-) decreased by 64.6% to 0.23 mmol/(L x min). The desulfurization efficiencies increase 3.8%-5.1% by adding Na2S in a pilot scale setup. It comes to conclusion that heavy metal ions precipitation by adding Na2S with an indicator of Mn2+ to inhibit catalytic oxidation of SO3(2-) is feasible to reduce the consumption of desulfurizer in FGD slurry.

Preparation of Adsorbent of Sodium Humate and Its Desulfurization Properties

Preparation of Sodium Humate/α-Aluminum Oxide Adsorbents for Flue Gas Desulfurization

Removal of SO2 from Flue Gas by Sodium Humate Solution

Removal of Sulfur Dioxide from Flue Gas Using the Sludge Sodium Humate

Simultaneous Removal of SO2 and NO2 on Α-Al2o3 Absorbents Loaded with Sodium Humate and Ammonia Water

Novel Process of Simultaneous Removal of SO<sub>2</sub>and NO<sub>2</sub>by Sodium Humate Solution

[Inhibition of Sulfite Oxidation Catalyzed by Heavy Metals in Dual Alkali Flue Gas Desulfurization Slurry].

Enhanced SO2 Absorption Capacity of Sodium Citrate Using Sodium Humate

A biomass-supported Na2CO3 sorbent for flue gas desulfurization.

A Biomass-Supported Na<sub>2</sub>CO<sub>3</sub>Sorbent for Flue Gas Desulfurization

Removal of So2 by A Mixture of Caprolactam Tetrabutyl Ammonium Bromide Ionic Liquid and Sodium Humate Solution

Preparation and NH4+-N Removal Performance of a Novel Filter Substrate Made from Sludges

Surfactant modified zeolite as adsorbent for removal of humic acid from water

Preparation of NaA zeolite molecular sieve based on solid waste fly ash by high-speed dispersion homogenization-assisted alkali fusion-hydrothermal method and its performance of ammonia-nitrogen adsorption

Studies on flue gas desulfurization by chemical absorption using an ethylenediamine-phosphoric acid solution

Preparation of Ammonia Adsorbent by Carbonizing and Activating Mixture of Biomass Material and Hygroscopic Salt

Study on the Treatment Mechanism of NH3-N-Containing Wastewater Using the Activated Sulphonated Coal from High Sulfur Coal

Desulfurization and Denitrification Performance of Modified Rice Husk Ash-Carbide Slag Absorbent

Adsorption of Humic Acid to Aminopropyl Functionalized SBA-15

Preparation and characterization of desulfurizer loaded on attapulgite

Adhesive Carrier Particles for Rapidly Hydrated Sorbent for Moderate-Temperature Dry Flue Gas Desulfurization