Abstract:Abstract The data acquisition system is widely used in electronic measuring instruments, for example, the oscilloscope . The development direction of the oscilloscope reflects the research status and development trend of the data acquisition system. Currently, the index of oscilloscopes is progressing toward a high sampling rate, and the performance of the analog‐to‐digital converter (ADC) has become the main bottleneck to improve the sampling rate of the acquisition system. The alternate sampling technology entails multichannel low sampling rate ADCs to achieve high sampling rate data acquisition through parallel sampling and realize data reconstruction through software. The sampling clock is the most important and difficult part of the system. For ADCs with the 100‐GS/s sampling rate and 10‐bit resolution, the jitter of the sampling clock needs to be in sub‐100 fs along with multiple phases. Based on the principle of injection locking, a 150‐GS/s sampling clock is proposed in this paper, which is implemented in a 0.15‐μm GaAs process, and the 50‐GHz locking range is achieved. The measurement results show that the sampling frequency is 150 GS/s, the root mean square (RMS) jitter is 63 fs with the integrated range from 1 kHz to 10 MHz, and the phase noise can meet the sampling requirements of the 10‐bit oscilloscope, which can provide a clocking scheme for small and low‐power ultrahigh‐speed oscilloscope.

A Low-Jitter Clock Generator for HDTV

A Novel Multiphase Clock Generator Based on Digital DLL Designed for Oversampling in Transceiver

Study and design of an on chip clock generator with high stability

2.5 Mw 2.73 GHz Non-Overlapping Multi-Phase Clock Generator with Duty-Cycle Correction in 0.13 Μm CMOS

A 2.4 mW 2.5 GHz multi-phase clock generator with duty cycle imbalance correction in 0.13 µm CMOS

A Low-Phase-Noise UHF-Band Fractional-N Frequency Synthesizer

Broadband Linearity Enhancement Method for a 1.3 GHz-2.5 GHz Digitally-Assisted Oscillator in a 55-Nm CMOS Technology

Design Of Low-Jitter 1-Ghz Phase-Locked Loops For Digital Clock Generation

A 10‐MHz to 50‐GHz low‐jitter multiphase clock generator for high‐speed oscilloscope in 0.15‐μm GaAs technology

A 1.8 V Low-jitter Clock Generator for 1000 Base-T Ethernet Transceiver

A 0.5-V, 0.05-to-3.2ghz LC-Based Clock Generator for Substituting Ring Oscillators under Low-Voltage Condition

A 2-GHz CMOS phase-locked loop clock generator research and design

Analysis and Design of Low-Jitter Clock Driver for Wideband ADC

A monolithic 1 GHz 0.6μm CMOS low jitter PLL

A Multiphase Clock Generation Based On Dll For Source Synchronous Receiver In 65nm Cmos Technology

Design of High-Performance Multiphase C Lock Generator Used in LVDS Driver with 0.25μm CMOS Technology

A Low-Jitter and Low-Power Frequency Synthesizer Applied to 1000Base-T Ethernet

A Low Spur, Low Jitter 10-Ghz Phase-Locked Loop in 0.13-Μm CMOS Technology

A 500 kHz to 150 MHz Multi-Output Clock Generator Using Analog PLL and Open-Loop Fractional Divider with 0.13 μm CMOS

A new on-chip jitter measurement method based on cumulative distribution function

A 4224 MHz Low Jitter Phase-Locked Loop in 0.13-Μm CMOS Technology