Abstract:Magnesium alloys show great promise in high-speed transport, aerospace, and military technology; however, their widespread adoption encounters challenges attributed to limitations such as poor plasticity and strength. This study examines the high-temperature deformation of semi-solid forged AZ91D magnesium alloy through a combination of experiments and simulations, with a focus on comprehending the influence of deformation conditions on dynamic recrystallization (DRX). The findings disclose that conspicuous signs of DRX manifest in the yield stress curve as strain increases. Additionally, decreasing the strain rate and temperature correlates with a reduction in both yield stress and peak strain, and the activation energy is 156.814 kJ/mol, while the critical strain and peak strain remain relatively consistent (εc=0.66208εp). Microstructural changes during high-temperature deformation and the onset of DRX are thoroughly examined through experimental methods. Moreover, a critical strain model for DRX and a predictive model for the volume fraction of DRX were formulated. These equations and models, validated through a combination of experiments and simulations, serve as invaluable tools for predicting the mechanical behavior and microstructural evolution, which also establishes a foundation for accurately predicting the deformation behavior of this alloy. By analyzing the hot deformation characteristics and dynamic compression mechanism of the newly developed semi-solid forging AZ91D magnesium alloy, a numerical simulation model can be effectively established. This model objectively reflects the changes and distributions of stress, strain, and rheological velocity, providing a scientific basis for selecting subsequent plastic deformation process parameters and designing mold structures.

Dynamic Compressive Behavior and Damage Mechanism of Cast Magnesium Alloy AZ91

Dynamic plasticity of AZ31 magnesium alloy: Experimental investigation and constitutive modeling

Microstructure in as-cast AZ61 magnesium alloy during hot compression deformation

Study on Dynamic Mechanical Properties of Magnesium Alloy AZ61

Failure Behavior of High Pressure Die Casting AZ91D Magnesium Alloy

High Strain-Rate Behavior and Deformation Mechanism of a Multi-Layer Composite Textured AZ31B Mg Alloy Plate

Dynamic mechanical response and microstructural evolution of extruded Mg AZ31B plate over a wide range of strain rates

Hot Deformation Characteristics and Dynamic Recrystallization Mechanisms of a Semi-Solid Forged AZ91D Magnesium Alloy

Influence of Strain Rate and Stress State on the Mechanical Behavior of Die-Casting AM60 Magnesium Alloy

Hot deformation behavior and microstructure evolution of as-cast AZ91D magnesium alloy without pre-homogenization treatment

Microstructure and Mechanical Properties of Squeeze Casting Quasicrystal Reinforced AZ91D Magnesium Matrix Composites

Microstructure of semi-solid AZ91D magnesium alloy after hot compression

High Cycle Fatigue Properties of Die-Cast Magnesium Alloy Az91d-1%Mm

Strain Rate and Temperature Effects on Formability and Microstructure of AZ31B Magnesium Alloy Sheet

Mechanical Behavior of AZ31B Magnesium Alloy Sheet at Different Strain Rates and Stress States

On the Deformation Behavior of Heterogeneous Microstructure and Its Effect on the Mechanical Properties of Die Cast AZ91D Magnesium Alloy

Hot Deformation Behaviors of AZ91 Magnesium Alloy: Constitutive Equation, Ann-Based Prediction, Processing Map and Microstructure Evolution

Deformation Behavior of AZ31B Magnesium Alloys with Different Process States under Thermal Compression

Tensile Deformation and Fracture of Unreinforced AZ91 and Reinforced AZ91-C at Temperatures up to 300 °C

Temperature-Dependent Flow Behavior and Microstructural Evolution During Compression of As-Cast Mg-7.7Al-0.4Zn

Microstructure Evolution of AZ91D Magnesium Alloy During High Temperature Compression