Abstract:_ This article, written by JPT Technology Editor Chris Carpenter, contains highlights of paper IPTC 22087, “One Innovative Intelligent Completion Intermediate String Design for Deepwater Gas-Well Completions: The Installation Case Study From L Gas Field, China,” by Shu Jie Liu, Yi Huang, and Wen Bo Meng, CNOOC, et al. The paper has not been peer reviewed. Copyright 2022 International Petroleum Technology Conference. Reproduced by permission. _ An intelligent completion design was installed in two wells in China’s L field deepwater project. Both wells have dual-zone stack-pack sand-control lower completions. To handle critical well-control concerns and enable production from each zone, an intermediate string was installed to isolate the reservoir in each zone temporarily. While the complete paper details both the completion string design and its field installation, this synopsis concentrates on the former aspect of the project. This practice will benefit upcoming deepwater well-completion designs, especially for high-pressure/high-temperature gas-field-development projects. Introduction The L field is a deepwater gas field in the Qiong Dongnan Basin with a water depth from 1200 to 1500 m in the South China Sea. The field was discovered in 2014; development launched in early 2018 with a plan for 11 development wells. The target zone of this field is over 3000 m true vertical depth with a widely distributed thin layer of sand deposition. The target zone has a normal pressure gradient of 1.2 and temperature that reaches 93°C. The 11 wells planned included six horizontal and five deviated wells. The openhole drilling of the first well began in April 2020, and the cased-hole intelligent completion of the last well was finished in March 2021. The openhole gravel packs in the first three wells were completed as the first batch. One cased-hole single-zone gravel pack was completed as the fourth well because it sat on the same flank of the reservoir as the first batch of three openhole wells. After that, a floating rig was mobilized on the other flank to complete the remaining three openhole wells. Then, the remaining two cased-hole single-zone gravel-pack completions followed. The most challenging completion, a dual-zone stack-pack intelligent completion, was performed in the last two wells in February and March 2021. A dedicated project manager and team were assigned throughout project execution. The project-management team strictly adhered to the operator’s completion project-management system; managed the interfaces, risks, and schedules through a scientific approach; and provided technical and troubleshooting support in a timely manner. All 11 wells were completed by April 2021, including the two intelligent well completions. The entire field was brought into production by mid-2021. Well-Completion Design Challenges Because of the unconsolidated sandstone present in the field, all 11 wells required a proper sand-control lower completion to eliminate the issue of sand production. However, the geologic conditions of widely distributed sand deposition and a thinly layered gas reservoir required the operator to use three different types of lower completion methods in one project: the openhole gravel-pack method for six horizontal wells to develop small and thin sand deposits, the single-zone cased-hole gravel-pack method for a sand-control completion in the three deviated wells, and the dual-zone stack-pack method for two intelligent completion wells for a dual-zone sand-control lower completion.

The plug-drilling-free staged cementing completion string

Development and Application of a Drilling Plug-free Staged Cementer

DRILLING FLUID TECHNIQUE OF GAS DRILLING TRANSLATION INTO CONVENTIONAL DRILLING

ERD Record in Shallow Weakly Consolidated Formation with Remarkable Efficiency

An efficient and fast shale oil cluster well drilling technology for Shengli Oilfield

Integrated Gas Lift Completion String for Ultra-deep Reservoir

Application of Staged Fracture Technology with Open-hole Packer in Shengli Oilfield

Research on the Technology of Integral Water Searching and Plugging for Two-Stage Casing Gas-Lift Wells in Sudan Oilfield

Intermediate String Design Enhances Intelligent Deepwater Completions

A New Drilling Fluid System for Temporary Plugging of Low Permeability Carbonate Reservoirs Containing H2S and CO2

Multistage Cementless Acid Fracturing in Sidetracking Slim Hole using Innovative Packers with Anti–Corrosive Thermo–Plastic Vulcanizates

A Successful Case Study from China's First Self-Operated Project Using an Openhole Shunted Screen Gravel-Pack Completion

Development and field application of downhole crosslinking plugging agent

Composite Plugging Removal Technology and Application in Low Permeability Oilfield

Using Cyclic Injection-production Technology to Improve the Development Effect of Water Flooding in Ultra-high Water Cut Stage

Cemented Multi Stage Fracturing Completion System – An Alternative to Open Hole MSF and Plug and Perf

Nano-Film-Forming Plugging Drilling Fluid and Bridging Cross-Linking Plugging Agent Are Used to Strengthen Wellbores in Complex Formations.

Design and experimental study of a new hydraulic tool for lost-circulation materials (LCM) plugging while drilling

Optimization of degradable temporary plugging material and experimental study on stability of temporary plugging layer

Decreasing Formation Damage with New Completion Methods in Daqing Oilfield