Abstract:Micro aerial vehicles flying at low speeds are becoming increasingly popular in military and daily life. Nevertheless, the short cruise time related to the poor aerodynamic efficiency of the wing at low Reynolds numbers is still a key issue. To deal with this, a spanwise plasma actuator array is used to reduce the zero-lift drag of a low-Reynolds-number airfoil, and experimental optimization of the electrical parameters is performed with intelligent algorithms. Results show that for efficient drag reduction, an unsteady unidirectional jet working mode should be preferred by the plasma actuator. In this mode, the drag reduction maps are mostly flat, and the drag reduction magnitude is insensitive to the variation of input voltage amplitude. There exists a threshold particle-observed Strouhal number (0.2) below which the drag reduction effectiveness drops sharply. As a comparison, the map of the power saving ratio shows a steep gradient, and its maximum always resides on the lower bound of duty cycle. With increasing freestream velocity, the mean drag reduction decreases monotonically. A genetic algorithm shows superior performance over surrogate-based optimization by reaching a maximum drag reduction of 40% and a peak power saving ratio of 0.7. Particle image velocimetry results reveal that there exists a laminar separation bubble on the airfoil. With plasma actuation, the transition location is shifted upstream, and the separation region is eliminated significantly. At low speeds, this pressure drag reduction exceeds the friction drag increase, resulting in a net drag decrease. However, transition-induced drag variation can only explain part of the total drag reduction, and the rest is inferred to be turbulent friction drag reduction.

Experimental investigation on airfoil stall separation suppression by plasma actuation

Experimental Investigation on Airfoil Stall Separation Suppression by Plasma Actuation

Experimental Investigation on Airfoil Suction Side Flow Separation by Pulse Plasma Aerodynamic Actuation

Compressor Airfoil Separation Control Using Nanosecond Plasma Actuation at Low Reynolds Number

Airfoil Flow Control Using DBD Plasma Actuators

Control of the Aero-Engine Nacelle Intake Flow Separation Caused by Crosswind Condition Using Plasma Actuation

A parametric study on control authority and vorticity transport in a compressor airfoil with plasma actuation at low Reynolds number

Flow Separation Control on Swept Wing with Nanosecond Pulse Driven DBD Plasma Actuators

Experimental Investigation and Intelligent Optimization of Airfoil Zero-Lift Drag Reduction with Plasma Actuators

Experiments of the flow field structure control around a circular cylinder based on plasma actuation

Plasma Actuator Separation Control Investigated with Spectral Proper Orthogonal Decomposition

Computational and experimental investigation of plasma aerodynamic actuation based corner flow separation control in a compressor cascade

Mechanism of Compressor Airfoil Boundary Layer Flow Control Using Nanosecond Plasma Actuation

Experimental Investigation of Nanosecond Discharge Plasma Aerodynamic Actuation

Simulation investigation on boundary layer of a plate flow control by plasma aerodynamic actuation

Experimental Investigation into Characteristics of Plasma Aerodynamic Actuation Generated by Dielectric Barrier Discharge

Shock Wave-Boundary Layer Interactions Control by Plasma Aerodynamic Actuation

Experimental Analysis of Flow Separation Control by a Dielectric Barrier Discharge Plasma Actuator in Burst-in-Burst Actuation Mode

Experimental Investigation On The Plasma Flow Control Of Axial Compressor Rotating Stall

Experimental Investigation of Enhancing Wing Aerodynamic Performance by Plasma Synthetic Jet

EXPERIMENTAL INVESTIGATION ON INDUCED FLOW VELOCITY OF PLASMA AERODYNAMIC ACTUATION