Abstract:The blast pressure acting on the borehole wall is the basis of the dynamic analysis of rock blasting. The history of blast-induced borehole wall pressure (BWP) is difficult to measure owing to the complex interaction between the blasting load and the borehole wall, and the limitations of the general test system. In this work, the complete history of BWP under air-deck charge was measured for the first time, and the stress-response process was analyzed. PVDF (polyvinylidene fluoride) gages and a charge mode for the test circuit were employed. To improve the testing accuracy, the matching relationships among the parallel capacitor, the equivalent capacitance of PVDF gages, and the parasitic capacitance of the coaxial cable were effectively addressed. The experimental data within the span of 0–0.65 m from the explosive cartridge center show that there are two obvious peaks in the complete history of BWP, the first is a μs-level air shockwave load, followed by a ms-level explosion gas load. The peak of BWP is dominated by the peak of explosion gas ( P g ) within the scope of about 0–0.35 m from the explosive cartridge center, while is mainly determined by the peak of air shockwave ( P s ) in a farther range. The specific impulse distribution suggests that the explosion energy is mainly consumed in the area within the range of about 0–0.25 m from the explosive cartridge center. The strain rate in the borehole wall induced by air shockwave demonstrates a dynamic response (range of 131.9 ~ 2922.6 s −1 ), while indicating a quasi-dynamic loading (range of 0.1 ~ 2.1 s −1 ) when induced by the explosion gas. The findings contribute to expanding the understanding of the stress characteristics of the air shock wave and explosion gas and provide accurate initial loads for numerical simulation related to rock blasting of non-fluid–solid coupling.

Blast wave stored testing and measuring technology

NON-CONTACT MEASUREMENT TECHNIQUE FOR DYNAMIC RADIAL DEFORMATION OF EXPLOSION CONTAINMENT VESSELS

Analysis of Energy Distribution for Digital Electronic Detonator Blasting

Experimental study on the use of the ARM Cortex M7 processor for measuring far-field blast waves

miniBLAST: a novel experimental setup for laboratory testing of structures under blast loads

Distributed Wireless Measurement System for Transient Pressure with Data Extraction Technology

Numerical Simulation of Shock Wave Caused by Underwater Blasting

Blast Wave Simulator for Laminated Glass Panels Experimental Evaluation

Measurement and Stress Response Analysis of Complete History of Blast-Induced Wall Pressure for Boreholes: A Case with Air-Deck Charge

A Device for Measuring Propagation Time of Ultrasonic Wave

Apparatus for skidding sensitivity testing of energetic materials

Device for Underwater Laboratory Simulation of Unconfined Blast Waves

Analysis of Energy Distribution of Accurate Millisecond Blasting Vibration

Application of tiny acceleration testing apparatus on the gatling weapon

High-precision measurement of refractive index in explosive-driven air blast waves for density and pressure determination

Blast responses of steel stiffened panels subjected to plane shock waves

Design and analysis of blast test of underground arch structure

Temporally and Spatially Resolved Reflected Overpressure Measurements in the Extreme Near Field

Experimental and Theoretical Analysis for Isolation Performance of New Combined Isolation Devices under Blast Loading

Identifying Delay Time of Detonator for a Millisecond Blasting

A new method for measuring the dynamic fracture toughness under blast loads using arc-edge rectangle with edge notches