Abstract:With the increased frequency of accidental and deliberate explosions, evaluating the response of civil infrastructure systems to blast loading has been attracting the interests of the research and regulatory communities. However, with the high cost and complex safety and logistical issues associated with field explosives testing, North American blast-resistant construction standards (e.g. ASCE 59-11 and CSA S850-12) recommend the use of shock tubes to simulate blast loads and evaluate relevant structural response. This study first aims at developing a simplified two-dimensional axisymmetric shock tube model, implemented in ANSYS Fluent, a computational fluid dynamics software, and then validating the model using the classical Sod’s shock tube problem solution, as well as available shock tube experimental test results. Subsequently, the developed model is compared to a more complex three-dimensional model and the results show that there is negligible difference between the two models for axisymmetric shock tube performance simulation; however, the three-dimensional model is necessary to simulate non-axisymmetric shock tubes. Following the model validation, extensive analyses are performed to evaluate the influences of shock tube design parameters (e.g. the driver section pressure and length and the expansion section length) on blast wave characteristics to facilitate a shock tube design that would generate shock waves similar to those experienced by civil infrastructure components under blast loads. The results show that the peak reflected pressure increases as the driver pressure increases, while a decrease in the expansion length increases the peak reflected pressure. In addition, the positive phase duration increases as both the driver length and expansion length are increased. Finally, the developed two-dimensional axisymmetric model is used to optimize the dimensions of a physical large-scale conical shock tube system constructed for civil infrastructure component blast response evaluation applications. The capabilities of such shock tube system are further investigated by correlating its design parameters to a range of explosion threats identified by different hemispherical TNT charge weight and distance scenarios.

miniBLAST: a novel experimental setup for laboratory testing of structures under blast loads

Research of Loading Effects of Blast in Air

Scaling laws for the rigid-body response of masonry structures under blast loads

Measurement, self-similarity, and TNT equivalence of blasts from exploding wires

Blast load simulation using conical shock tube systems

Numerical Simulation of Blast Loads and Dynamic Response of Reinforced Concrete Slab Subjected to Close-in Explosion

Temporally and Spatially Resolved Reflected Overpressure Measurements in the Extreme Near Field

Blast Wave Simulator for Laminated Glass Panels Experimental Evaluation

Validation study on numerical simulation of RC response to close-in blast with a fully coupled model

Experimental investigation of band-beam slabs subjected to close-range blast loading

Dynamic response of reinforced masonry structure under blast load

Integrated experimental platforms to study blast injuries: a bottom-up approach

A shock tube facility to generate blast loading on structures

Field Test and Elastic Dynamic Response Analysis of Shallow-Buried Utility Tunnel under Explosion Load

Dynamic Structural Assessment of Blast Wall Designs on Military-Based Vehicle Using Explicit Finite Element Approach

Experimental and Numerical Study of Non-Explosive Simulated Blast Loading on Reinforced Concrete Slabs

Dynamic responses of buried arch structure subjected to subsurface localized impulsive loading: Experimental study

Device for Underwater Laboratory Simulation of Unconfined Blast Waves

Numerical Simulation of Masonry Walls Subjected to Blast Loads

Blast Resistance of Small-Scale RCS in Experimental Test and Numerical Analysis

Behavior of steel liner tray walls under external blast: Experimental testing and numerical simulations