Abstract:The primary objective of this study is to investigate the potential of using microscopic simulation models and Surrogate Safety Assessment Model (SSAM) for evaluating the safety performance of signalized intersections. A widely used microscopic simulation package VISSIM was used in this study to develop simulation models. The validity of using VISSIM and SSAM for traffic safety analysis at signalized intersections was tested by comparing the simulated conflicts to those measured in the field using traditional traffic conflicts techniques. Of particular interest was to identify if the consistency between simulated and observed conflicts could be improved by calibrating VISSIM simulation models and adjusting threshold values used for defining simulated conflicts in SSAM. A two-stage procedure was proposed in this study to develop, calibrate and validate VISSIM simulation models. It was found that the two-stage calibration procedure greatly improved the goodness-of-fit between simulated conflicts and real-world conflicts. After model calibration, the mean absolute percent error (MAPE) for total conflicts was reduced from 44% to 24%. More specifically, the MAPE value was reduced from 26% to 15% for rear-end conflicts, from 69% to 29% for crossing conflicts, and from 83% to 81% for lane-change conflicts. Linear regression models and the spearman rank correlation coefficient were also developed to study the relationship between simulated conflicts and observed conflicts. Data analysis results showed that there was a reasonable goodness-of-fit between simulated and observed rear-end and crossing conflicts. However, it was also found that the simulated conflicts generated by VISSIM and SSAM are not good indicators for traffic conflicts which are generated by unexpected driving maneuvers such as illegal lane-changes in the real world.

Analysis of Signalized Intersection Safety Spacing of Multi-lane Based on Traffic Flow Stability Distance

Critical Traffic Volume of Traffic Signal Warrant at Major-Minor Intersections

Evaluating Stability and Performance in Mixed Traffic: A Theoretical and Co-Simulation Approach

Influence of Stretching-Segment Storage Length on Urban Traffic Flow in Signalized Intersection

Determination Method of Critical Traffic Volume for Signal Setting at T-Intersections

Critical Traffic Volume Warrant of Signal Installing at Equal Weight Intersections

Influence of signal on the capacity of signalized intersection

Analysis om waiting area for left-turn vehicles at signalized intersections

Minimum Cycle Length of Two-Phase Road Intersection

Critical traffic volume of traffic signal warrant under limited priority condition

Optimization of Stretching-Segment Design and Signal Timing in Traffic Control

A Method of Signal Timing Optimization for Spillover Dissipation in Urban Street Networks

Calculation Method of Critical Coordination Link Length Between Two Adjacent Intersections

Maximum cycle length optimization method of signalized intersection

Development of a Procedure for Using Surrogate Safety Assessment Model and VISSIM for Safety Assessment at Signalized Intersections

Simulation of Departure Flow Profile at Stop Lines for Signal Approach Spillover

Inter-green interval calculation for signalized intersections

Evaluation of signaled intersection status under capacity of sections

Analyze Correlations of Traffic Control Plans in Urban Road Networks

Traffic Design and Signal Timing of Staggered Intersections Based on a Sorting Strategy

A Group-Based Signal Timing Optimization Model Considering Safety for Signalized Intersections with Mixed Traffic Flows