Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Effect of Restrain on the Deformation of Sheet Metal in Laser Curve Forming

Preliminary Studies on Strain Rate Dependence of Laser Shock Forming

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Numerical Simulation Research on Laser Shock Forming of Thin Metal Sheet

Deformation Behaviours of Laser Curve Bending of Sheet Metals

Numerical Simulation Research on Laser Shock Forming

Influence of the Deformation of Riveting-Side Working Head on Riveting Quality

The Effect of Elastic Pre-Bending on the Laser Peen Forming of 2024-T351 Aluminum Alloy Plate

Analysis and Simulation of Machining Deformation Resulting from Residual Stress

Investigation on the bending deformation of laser peen forming with a simplified eigenstrain-based finite element model

Experiments and Numerical Simulations on Laser Welding Deformation of Thin Plate Considering Constraint Clamp

Effect of Interlayer Cooling Time, Constraint and Tool Path Strategy on Deformation of Large Components Made by Laser Metal Deposition with Wire

Process and Development of Laser Forming

The Effect of Unloading Positions and Times on Sheet Metal’s Stress-Strain Curve

GLARE deformation in low-restraint state: Tensile and bending behavior

Microstructure and Mechanical Property Characterizations of Metal Foil after Microscale Laser Dynamic Forming

Research on the Mechanism and Processability of Roll Forming

Effect of constraint on fracture performance of Ti6Al4V alloy fabricated by laser powder bed fusion

Experimental and Numerical Simulation of Sheet Bulging Induced by Laser Shock Peening

Studies on Laser Forming of Ti–6Al–4V Alloy Sheet

Study on deformation difference between the contact zone and the non-contact zone of the flexible 3D stretch bending profile and roller dies based on pre-stretching amount