Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Research on Adiabatic Capillary Tubes′ Correlation of R134a Unit Air-conditioning

Numerical Simulation and Experimental Study of Capillary Tubes

A generalized correlation for the characteristics of adiabatic capillary tubes

Simulation on the Performance of Adiabatic Capillary Tubes With R410A Refrigerant

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Experimental investigation on the condensation heat transfer coefficient and frictional pressure drop of R-513A and R-134a in commercial refrigeration tubes

Research on R134a Water-cooling Condenser Using External Micro-fin Tube

Design of evaporator of R134a unit air-conditioning

An improved correlation for condensation heat transfer of R-134a in horizontal tubes

Experimental Evaluation of Condensation of R32 and R134a over a Plain Tube

Comparison Between Model-established Simulation and Experiment for Evaporators

EXPERIMENTAL INVESTIGATION ON FORCED CONVECTIVE CONDENSATION HEAT TRANSFER OF R32/R134a MIXTURES

Experimental study of in-tube cooling heat transfer and pressure drop characteristics of R134a at supercritical pressures

Design of condenser for unit air-conditioning using R134a

STUDY ON FLOW BEHAVIOR OF R22 ALTERNATIVE REFRIGERANT IN CAPILLARY TUBE

Measurement and Correlation Development of the Diffusion Coefficient of R32 in Lubricating Oil

Sizing Charts of Helical Capillary Tubes Used in Refrigeration and Air Conditioning

An Experimental Study of R410A Condensation Heat Transfer and Pressure Drops Characteristics in Microfin and Smooth Tubes with 5 Mm OD

General Simple Model for Adiabatic Capillary Tubes Based on the Identification of Average Specific Volume Using Artificial Neural Network

Flow Condensation Heat Transfer Correlation Development of R32-oil Mixture Inside a Micro-Fin Tube

Experiment of condensation and heat transfer for R134a refrigerant in micro-channel heat exchanger