Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

An improved correlation for condensation heat transfer of R-134a in horizontal tubes

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Theoretical Analysis and Experimental Investigation on Local Heat Transfer Characteristics of HFC-134a Forced-Convection Condensation Inside Smooth Horizontal Tubes

Experimental Study on Condensation Heat Transfer of Horizontal Enhanced Tubes for R134a

Flow Boiling Heat Transfer Characteristic of Refrigerant R1234ze(E) in Horizontal Circular Tube

Numerical Investigation on Condensation Heat Transfer and Pressure Drop Characteristics of R134a in Horizontal Flattened Tubes

Condensation Heat Transfer Experiments of R410A and R32 in Horizontal Smooth and Enhanced Tubes

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Experimental study on condensation heat transfer characteristics of R410A in short vertical tubes

Research on the R513A condensation heat transfer characteristics in horizontal microfin tubes

Condensation heat transfer and pressure drop characteristics inside smooth and enhanced tubes with R410A and R32

Heat Transfer Correlations of Refrigerant Falling Film Evaporation on a Single Horizontal Smooth Tube

Condensation Heat Transfer of R410A on Outside of Horizontal Smooth and Three-Dimensional Enhanced Tubes

A numerical study of condensation heat transfer and pressure drop in horizontal round and flattened minichannels

Experimental Study on the Flow Condensation Heat Transfer of R290 and R22 in a Horizontal Circular Minitube

Heat Transfer Correlation of the Falling Film Evaporation on a Single Horizontal Smooth Tube

An Experimental Study of R134a Condensation Heat Transfer in Horizontal Smooth and Enhanced Tubes

Experimental Investigation on Condensation Heat Transfer in Horizontal Microfin and Smooth Tube with Refrigerant R22

An Experimental Study of R410A Condensation Heat Transfer and Pressure Drops Characteristics in Microfin and Smooth Tubes with 5 Mm OD

Experimental research on refrigerant condensation heat transfer and pressure drop characteristics in the horizontal microfin tubes

Condensation heat transfer and pressure drop of r134a in horizontal micro-scale enhanced tube