Experimental Study on Hysteretic Behavior of High Strength Steel Box-Section Columns

施刚,邓椿森,班慧勇,陈以一,王元清,石永久

DOI: https://doi.org/10.14006/j.jzjgxb.2012.03.001

2012-01-01

Abstract:In order to study the seismic behavior of Q460 high strength steel box-section columns,5 full-scale specimens were tested under cyclic loading. The influences of the width-to-thickness ratio and axial-load ratio on the load carring capacity,failure modes,energy dissipation capacity,deformation capacity and ductility were analyzed. The test results indicate that Q460 high strength steel box-section columns have excellent energy dissipation capacity and seismic behavior and are applicable for seismic steel frames. No welds of the specimens or the column bases except specimen HB-1 crack,which proves that Q460 high strength steel welds by reasonable design and qualified quality have enough load carrying capacity and seismic behavior. With higher plate width-to-thickness ratio,local buckling occurs earlier,the displacements corresponding to the maximum load carrying capacity and ultimate failure are both smaller,and the ratios of the range and the center of the local buckling to the specimen section height decrease. The distance between the maximum local buckling position and the fixed end for all the specimens is 0. 25B ～ 0. 50B. The plastic range is 0. 72 B ～ 1. 06 B . Based on the test results,it is suggested that,the plate slenderness limiting value for Q460 high strength box-section columns is 30 when the axial-load ratio is not greater than 0. 2. The width-tothickness ratio limiting values for steel columns should be related to the axial-load ratio.