Abstract:Laser stabilization sits at the heart of many precision scientific experiments and applications, including quantum information science, metrology and atomic timekeeping. These systems narrow the laser linewidth and stabilize the carrier by use of Pound-Drever-Hall (PDH) locking to a table-scale, ultra-high quality factor (Q), vacuum spaced Fabry-Perot reference cavity. Integrating these cavities, to bring characteristics of PDH stabilization to the chip-scale, is critical to reduce their size, cost, and weight, and enable a wide range of portable and system-on-chip applications. We report a significant advance in integrated laser linewidth narrowing, stabilization and noise reduction, by use of a photonic integrated 4.0-meter-long coil resonator to stabilize a semiconductor laser. We achieve a 36 Hz 1/{\pi}-integral linewidth, an Allan deviation (ADEV) of 1.8x10^{-13} at 10 ms measurement time, and a 2.3 kHz/sec drift, to the best of our knowledge the lowest integral linewidth and highest stability demonstrated for an integrated reference cavity. Two coil designs, stabilizing lasers operating at 1550 nm and 1319 nm are demonstrated. The resonator is bus coupled to a 4.0-meter-long coil, with a 49 MHz free spectral range (FSR), a mode volume of 1.0x10^{10} {\mu}m^3 and a 142 million intrinsic Q, fabricated in a CMOS compatible, ultra-low loss silicon nitride waveguide platform. Our measurements and simulations show that the thermorefractive noise floor for this particular cavity is reached for frequencies down to 20 Hz in an ambient environment with simple passive vibration isolation and without vacuum or thermal isolation. The TRN limited performance is estimated to be an 8 Hz 1/{\pi} integral linewidth and ADEV of 5x10^{-14} at 10 ms, opening a stability regime that heretofore has only been available in fundamentally un-integrated systems.

Contribution of Thermal Noise to Frequency Stability of Rigid Optical Cavity Via Hertz-linewidth Lasers

Thermal Noise in Cubic Optical Cavities

Laser frequency instability of 2 × 10 -16 by stabilizing to 30-cm-long Fabry-Pérot cavities at 578 nm.

A systematic study of thermal noise limited stability of rigid Fabry-Perot cavities

Coherent photo-thermal noise cancellation in a dual-wavelength optical cavity for narrow-linewidth laser frequency stabilisation

Fiber-coupled 2 mL vacuum-gap Fabry-Perot reference cavity for portable laser stabilization

An Ultrastable 1397-Nm Laser Stabilized by a Crystalline-Coated Room-Temperature Cavity.

Stabilization of an Integrated Laser with an 8 Ml Fabry-Pérot Optical Reference Cavity

8E-17 fractional laser frequency instability with a long room-temperature cavity

Improvement of the Intensity Noise and Frequency Stabilization of Nd:YAP Laser with an Ultra-Low Expansion Fabry-Perot Cavity

Cryogenic sapphire optical reference cavity with crystalline coatings at 1 × 10-16 fractional frequency instability

Laser Frequency Instability of 6X10-16 Using 10-Cm-long Cavities on a Cubic Spacer

Ultra-stable 1064-nm neodymium-doped yttrium aluminum garnet lasers with 2.5 × 10-16 frequency instability

Locking the frequency of lasers to an optical cavity at the $1.6 \times 10^{-17}$ relative instability level

36 Hz integral linewidth laser based on a photonic integrated 4.0-meter coil resonator

Microresonator-stabilized extended-cavity diode laser for supercavity frequency stabilization

A Vibration-Insensitive Optical Cavity and Absolute Determination of Its Ultrahigh Stability.

Laser noise in cavity-optomechanical cooling and thermometry

Cryogenic sapphire optical reference cavity with crystalline coatings at $\mathrm{ 1 \times 10^{-16}}$ fractional instability

Ultrastable lasers based on vibration insensitive cavities