Tool-path Generation Algorithm of Sculptured Surface by 3-Axis Swing Grinding

范立成,杜志江,孙立宁
DOI: https://doi.org/10.13196/j.cims.2008.07.171.fanlch.015
2008-01-01
Abstract:In conventional Numerical Control(NC) machining of sculptured surface based on triangular facet model,to calculate each Cutter Location(CL) point of the flatted cutter,only few facets were actually used in the calculation of the tool projection region.However,most calculations were conducted to search those triangular facets overlapped by the tool projection region from the total facet set.To overcome such weakness,a novel rectangle envelope method was proposed,in which most facets outside the projection region were filtered out.During the course of a searching process,all facets overlapped by the tool projection region were saved independently so as to avoid searching the total STL(STereo Lithography) file again in next steps.For each facet overlapped by the tool projection region,the CL point was calculated by the cutter contract points with the vertexes,sides and the plane,finally the tool-path was obtained.Simulation experiment was used to demonstrate the feasibility of the proposed method.
What problem does this paper attempt to address?