Abstract:A combined steady-state and transient approach is employed to investigate the corrosion behavior of X80 pipeline steel in carbon dioxide-saturated brines. Continuous bubbling of carbon dioxide into a test vessel with 1 liter capacity is performed to simulate the flowing condition. The measurement of time-dependent open-circuit potential, polarization resistance, and electrochemical impedance spectroscopy (EIS) is conducted to interpret the evolution of dissolution processes at the corroding interface. Three distinguishing stages are observed at a temperature of 60 °C during a whole exposure of 144 h. Analyses mainly based on the consecutive mechanism show that after the first stage of the active-adsorption state, the anodic reaction is significantly retarded by the accumulation of (FeOH)ads on the iron surface, causing a sharp increase in the polarization resistance and the open-circuit potential, as well as the disappearance of the inductive loop in EIS. At the third stage, the formation of the corrosion product layer similarly reduces both the anodic and cathodic reactions, which arouses a linear increase in the polarization resistance with time and a capacitive loop in EIS but changes the open-circuit potential slightly. An increase in salinity in this study reduces the polarization resistance and enhances iron dissolution by promoting the formation and relaxation of (FeOH)ads; however, it brings little change to the developing time of the three stages obviously. At a low temperature of 20 °C, a protective product layer is not observed in carbon dioxide-saturated brine, and the dissolution of iron is mainly under activation control during the whole exposure. A notable enlarged polarization resistance and different interfacial processes are observed in an alkaline solution compared with those in acidic environments, which is deduced to be resulted from an impedance in the relaxation of (FeOH)ads by increasing pH. The observations in this study support well that the iron dissolution reaction at the initial stage exposed in carbon dioxide aqueous environments is dominant by water adsorption on the iron surface, and further investigation should be performed on the role that carbon dioxide plays in the evolution of corrosion products and the formation of a protective film on the steel surface by taking into account local water chemistry.

Determination of Corrosion Rate of Oil Pipe Made of Steel in Acidic Fluid by Spectrophotometry

Use of Oxidation-Reduction Potential to Monitor Iron Release from Corroded Iron Pipes in Drinking Water Distribution System

Effects of Chloride and Humic Acid on Iron Release in Water Distribution System

Corrosion Behaviors and Mechanical Properties of Q235 Steel Pipes Collapsing Due to Corrosion after 25-Year Service in Urban Industrial Atmospheric Environment

Summarization of High-temperature Naphthenic Acid Corrosion and Its Control Technique on Pipeline

Investigation into main controlling factors and prediction model of L245NS steel corrosion rate in CO2–O2–SO2–H2S–H2O environment

Corrosion Detection Technology for Surface Gathering Carbon Steel Pipeline in Oil and Gas Field

On-Line Measurement and Characterization of Electrochemical Corrosion of 304L Stainless Steel Pipe Wall in High-Speed Cl-Containing Solution

INFLUENCE OF TEMPERATURE,CO_2 PARTIAL PRESSURE, FLOW RATE AND pH VALUE ON UNIFORM CORROSION RATE OF X65 PIPELINE STEEL

A Method to Measure the Soil Corrosive Rate of Pipe Material

Experimental Investigation on Corrosion Behavior of X80 Pipeline Steel under Carbon Dioxide Aqueous Conditions

Research on the Corrosion Behavior of Q235 Pipeline Steel in an Atmospheric Environment through Experiment

Atomic Absorption Spectrophotometry Measuring the Content of Iron in the Water

Corrosion Mechanism of Oil Field Gathering Pipeline Containing Small H2S Impurity

Factors Influencing the CO2 Corrosion Pattern of Oil–Water Mixed Transmission Pipeline during High Water Content Period

Development of facile field-test paper for rapid determination of iron contamination in natural water of acid sulfate soils

Anodic Dissolution Characteristics of the X80 Pipeline Steel in Simulated Soil Solution

Experimental Investigation of the Effects of Different Environmental Conditions on Pipelines Corrosion Rates

Research on pitting corrosion characteristics of X90 steel based on acoustic emission and electrochemistry methods

Determination of Trace Iron by Spectrophotometry with Oxidizing Discoloration Reaction of Acid Fuchsine

Corrosion Behavior of X80 Steel in a Simulated Soil Solution Under Square-Wave Current Interference