Abstract:The friction and wear properties of the polyetheretherketone (PEEK) based composites filled with 5 mass% nanometer or micron Al2O3 with or without 10 mass% polytetrafluroethylene (PTFE) against the medium carbon steel (AISI 1045 steel) ring under the dry sliding condition at Amsler wear tester were examined. A constant sliding velocity of 0.42ms−1 and a load of 196 N were used in all experiments. The average diameter 250μm PEEK powders, the 15 or 90nm Al2O3 nano-particles or 500nm Al2O3 particles and/or the PTFE fine powders of diameter 50μm were mechanically mixed in alcohol, and then the block composite specimens were prepared by the heat compression moulding. The homogeneously dispersion of the Al2O3 nano-particles in PEEK matrix of the prepared composites was analyzed by the atomic force microscopy (AFM). The wear testing results showed that nanometer and micron Al2O3 reduced the wear coefficient of PEEK composites without PTFE effectively, but not reduced the friction coefficient. The filling of 10 mass% PTFE into pure PEEK resulted in a decrease of the friction coefficient and the wear coefficient of the filled composite simultaneously. However, when 10 mass% PTFE was filled into Al2O3/ PEEK composites, the friction coefficient was decreased and the wear coefficient increased. The worn scars on the tested composite specimen surfaces and steel ring surfaces were observed by scanning electron microscopy (SEM). A thin, uniform, and tenacious transferred film on the surface of the steel rings against the PEEK composites filled with 5 mass% 15nm Al2O3 particles but without PTFE was formed. The components of the transferred films were detected by energy dispersive spectrometry (EDS). The results indicated that the nanometer Al2O3 as the filler, together with PEEK matrix, transferred to the counterpart ring surface during the sliding friction and wear. Therefore, the ability of Al2O3 to improve the wear resistant behaviors is closely related to the ability to improve the characteristics of the transfer film.

Preparation and tribological properties of polyetheretherketone composites.

Tribological behavior of modified polyetheretherketone composites in sliding against stainless steel under water lubrication

Tribological properties of kaolin filled UHMWPE composites in unlubricated sliding

Tribological Behavior of Three‐dimensional Braided Carbon Fiber Reinforced Polyetheretherketone Composites

Tribological Research on Polyetheretherketone Self-lubricating Composites and Applications

Tribological Performance Study of Low-Friction PEEK Composites under Different Lubrication Conditions

Preparation of CF/PEEK and Study on Friction Performance

Effect of CaCO_3 Whisker and PTFE on Dry Friction Behavior of PEEK

On the tribological behaviour and mechanism of poly(ether ether ketone)

Tribological properties of nano-Al2O3/PEEK composites

Friction and Wear Behaviors of PTFE-based Composites Filled with Polymers

Tribological Behaviour of Polymeric Coatings: II. SCF‐Reinforced PEEK Nanocomposite Systems

Tribology studies on the wear resistance PEEK composites for automobile

The Research of Polyetheretherketone Based Composite Coatings

Friction And Wear Behavior Of Polyetherimide(Pei) Filled With Polytetrafluoroethylene(Ptfe)

A study on friction and wear characteristics of nanometer Al2O3 /PEEK composites under the dry sliding condition

Tribological Properties of PEEK and Its Composite Material under Oil Lubrication

Enhanced Tribological Properties of PEEK‐based Composite Coatings Reinforced by PTFE and Graphite

Study on the friction and wear behavior of peek composites filled with nanometer compounds and PTFE

Performance and mechanisms of different tribological thermoplastic composites in sliding contact with steel