Abstract:Purpose: To investigate the effect of H2O2/HCl heat treatment on peri-implant bone formation in vivo. Materials and Methods: Twenty Ti-6Al-4V implants and 30 Ti-6Al-4V discs were used in this study. The implants and discs were separated into 2 groups: sandblasted and dual acid-etched group (control group) and sandblasted, dual acid-etched and H2O2/HCl heat-treated group (test group). Surface morphology, roughness, and crystal structure of the discs were analyzed by field-emission scanning electron microscopy, atomic force microscopy, and low angle X-ray diffractometry. The implants were inserted into the femurs of 10 adult white rabbits. Animals were injected with fluorescent bone labels at 1, 5, and 7 weeks following surgery to monitor progress of bone formation. Animals were euthanized 8 weeks postsurgery, and block biopsies were prepared for histologic and histometric analysis. Results: Microscopic evaluation showed the surfaces were quite irregular for both techniques; however, the test surface demonstrated consistently smaller surface irregularities. The differences in Sa values were significant (P = .022). No significant differences were found in the maximum peak-to-valley ratio values (P = .258). X-ray diffractometry analysis showed that titanium dioxide was found on the test surface. New bone was formed on both implant surfaces. The bone-implant contact pattern appeared to produce a broad-based direct contact. Test implants demonstrated 7.13% more bone to implant contact (P = .003) and 15.42% more bone to implant contact for 3 consecutive threads (P = .001) than control implants. Test implants demonstrated 37.04% more bone area 500 mu m outside of implant threads (P = .004) and 51.97% more bone area within 3 consecutive threads (P = .001) than control implants. No significant differences were found in bone area within all implant threads between the two groups (P = .069). Conclusion: This study demonstrated that implants heat-treated with H2O2/HCl solution enhanced peri-implant bone formation. INT J ORAL MAXILLOFAC IMPLANTs 2008;23:1020-1028.

[Analysis of Apposition on Differently Treated Implant Surface at Early Stage of Implantation].

The analysis of the bone response to the different treated implant surfaces at early stage of implantation

Early bone response to sandblasted, dual acid-etched and H2O2/HCl treated titanium implants: an experimental study in the rabbit

In Vivo Comparison of Bone Formation on Titanium Implant Surfaces Coated with Biomimetically Deposited Calcium Phosphate or Electrochemically Deposited Hydroxyapatite

Biomechanical and Morphometric Evaluation of a Strontium-Incorporated Implant and Four Commercially Available Implants: A Study in Rabbits

Strontium-incorporated Titanium Implant Surface Treated by Hydrothermal Reactions Promotes Early Bone Osseointegration in Osteoporotic Rabbits

Bone Responses to Titanium Implants Surface-Roughened by Sandblasted and Double Etched Treatments in a Rabbit Model.

Histological Observation of the Interface of Oral Epithelium and Titanium Implant with Titanium Dioxide on the Surface

Biomechanical comparison of biomimetically and electrochemically deposited hydroxyapatite-coated porous titanium implants.

Effects of biomimetically and electrochemically deposited nano-hydroxyapatite coatings on osseointegration of porous titanium implants.

Bone Responses to Rough Titanium Implants Coated with Biomimetic Ca-P in Rabbit Tibia.

Effect of Strontium-Substituted Nanohydroxyapatite Coating of Porous Implant Surfaces on Implant Osseointegration in a Rabbit Model.

Effect of H2O2/HCl Heat Treatment of Implants on in Vivo Peri-Implant Bone Formation.

Fluorescence Microscopic Analysis of Bone Osseointegration of Strontium-Substituted Hydroxyapatite Implants.

Bonding of Chemically Treated Titanium Implants to Bone.

Biological and Biomechanical Behavior of Titanium Implants with Fluoridated Hydroxyapatite Coatings

Effect of Electrochemically Deposited Nanohydroxyapatite on Bone Bonding of Sandblasted/Dual Acid-Etched Titanium Implant

Osteoblast Responses to Thin Nanohydroxyapatite Coated on Roughened Titanium Surfaces Deposited by an Electrochemical Process.

Effects of Zinc-Substituted Nano-Hydroxyapatite Coatings on Bone Integration with Implant Surfaces

Bone Response to the Multilayer BMP-2 Gene Coated Porous Titanium Implant Surface.

Biological Efficacy of Modified Structure of Polymer Surfaces for Bone Substitute