Abstract:This paper presents a commutation torque ripple suppression method based on the minimum phase shift angle (MPSA) of hall signals. It is implemented through shifting hall signals by the MPSA and the MPSA is derived based on the unit duty cycle of the incoming and non‐commutation phase. With the proposed method, the reliability is enhanced and no hardware is required, which reduces design cost and volume size. Finally, the proposed method is verified through simulation and experimental results. Summary Commutation torque ripple occurs when brushless DC (BLDC) motor runs in the high‐speed range, which degrades operation performance. To overcome the problem, this paper presents a commutation torque ripple suppression method based on the minimum phase shift angle (MPSA) of hall signals. In the paper, the effect of the phase shift angle (PSA) of hall signals on phase current is analyzed, and the MPSA is deduced on the basis of the unit duty cycle of the incoming and non‐commutation phase. With the proposed method, two‐phase conduction mode is used in the full speed range, commutation period and non‐commutation period, which avoids switching modulation mode and enhances system reliability. The proposed method is implemented through shifting hall signals by the MPSA, and it is simple and feasible without the requirement to redesign a controller. Moreover, no additional power devices and precise sensors are required, which reduces design cost and volume size. The proposed method is experimentally compared with different methods under steady operation condition, and the results show superior performance on suppressing commutation torque ripple. The loading experiment demonstrates that the proposed method exhibits good dynamic response. The frequency spectrum of the electromagnetic torque is analyzed, and it is verified that the 6nf harmonics are diminished with the proposed method.

Suppression of torque ripple due to phase commutation in brushless DC motor drives considering the stator resistance

Research on PWM Method in Brushless DC Motor

Reduction of Commutation Torque Ripple in Brushless DC Motors

Steady Performance Analysis on Single-Phase Brushless DC Motor

Torque Ripple Suppression Control for Dual Three-Phase Permanent-Magnet Synchronous Motor

Torque ripple suppression of brushless dc motors with non-ideal back EMF for EPS applications

A Novel Strategy to Suppress Commutation Torque Ripple in Brushless DC Motor Based on Unitive Formula

Commutation torque ripple suppression method for brushless DC motors with minimum phase shift angle

Commutation Torque Ripple Restraint in BLDC Motor over Whole Speed Range

Control Analysis of PM Brushless DC Motor Used in Flywheel Energy Storage System

Research on Suppressing Commutation Torque Ripple of BLDCM Based on Zeta Converter

Torque Ripple Reduction of Brushless Dc Motor on Current Prediction and Overlapping Commutation

Model Predictive Control Method of Torque Ripple Reduction for BLDC Motor

A Novel PWM Scheme to Eliminate the Diode Freewheeling in the Inactive Phase in BLDC Motor

Adaptive Torque Ripple Suppression Methods of Three-Phase PMSM During Single-Phase Open-Circuit Fault-Tolerant Operation

Research on BLDC Motor Torque Ripple with Specific Modulation Duty Cycle Control During Commutation

Optimal Duty Cycle Method to Suppress the Commutation Torque Ripple of Brushless DC Motor in Braking Mode

Torque ripple reduction of BLDC motor based on DC bus voltage automatic selection circuit and neutral point clamped three-level inverter control

A Practical Method to Eliminate the Conduction Torque Ripple in BLDCM Using Cascade Topology

Torque Ripple Suppression Method with Reduced Switching Frequency for Open-Winding PMSM Drives with Common DC Bus.

Analysis and Simulation on Commutation Torque Ripples of Six-Phase Brushless DC Motor