Abstract:Current research has shown a nonlinear trend in the failure of soil, and the single tangent method is commonly adopted when coping with nonlinear problems of soil failure. However, the method equates a nonlinear criterion to an optimizable linear criterion, which may differ from the actual situation, resulting in conservative results. In this paper, two types of piece-wise log-spiral failure mechanisms for bearing capacity estimations, including symmetrical and unilateral mechanisms were proposed with the nonlinear Mohr-Coulomb criterion. The static bearing capacity of foundations was evaluated using the symmetric failure mechanism, while the seismic bearing capacity of foundations was evaluated adopting a modified pseudo-dynamic method based on the unilateral failure mechanism. The result shows that the bearing capacity calculated in the paper is smaller compared to the result using the linear Mohr-Coulomb criterion. For London clay, the static bearing capacity is reduced by about 45% at a foundation width equal to 1m. From the comparisons, it is found that the proposed approach of piece-wise log-spiral failure mechanism for bearing capacity estimation is effective. In addition, parametric studies show that the nonlinear parameters, the initial factor of seismic acceleration, the normalized frequency, and the damping ratio all have obvious effects on the seismic bearing capacity. A significant reduction in the seismic bearing capacity of the foundation occurs when the normalized frequency ω s H / V s is equal to (0.5 + n ) π ( n = 0, 1, 2, ...). Considering that the approach proposed provides a strict upper bound to the bearing capacity, the result imparts confidence in the approach of analysis presented.

Analysis of Bearing Capacity for Strip Footings by Reproducing Kernel Particle Method

THE CRITICAL EDGE LOAD OF COMPOSITE GROUND REINFORCED BY STONE COLUMNS UNDER RIGID FOUNDATION

Multiscale Modelling and Analysis of Footing Resting on an Anisotropic Sand

Effect of Fabric Anisotropy on Bearing Capacity and Failure Mode of Strip Footing on Sand: an Anisotropic Model Perspective

Calculation of ultimate bearing capacity factor N gamma for rough strip footings

The Bearing Capacity Factor Nγ of Strip Footings on C–ϕ–γ Soil Using the Method of Characteristics

Semi-empirical Solution on Bearing Capacity of Strip Footing Considering Unit Weight of Soil

Solution and error evaluation for bearing capacity of rough strip footings

Stability analysis of elasto-plastic soil slope by reproducing kernel particle method

STUDY ON COEFFICIENT β IN BEARING CAPACITY FORMULA OF CFG PILE COMPOSITE FOUNDATION

Influence of the superposition and flow rule assumptions on the bearing capacity of shallow strip footings

Oblique and eccentric bearing capacity of embedded strip footings using the method of rigorous characteristics

Calculation Method of Uplift Capacity of Pile-Anchor Composite Foundation and Influence of Parameters

Kinematic bearing capacity analysis of strip footings on reinforced soils using discretisation technique

Mesomechanical analysis of bearing characteristics of pile-supported embankment with particle flow code

Seismic Bearing Capacity of Strip Footings with Modified Pseudo-dynamic Method

Discussion of Influent Factors of Slope Stability Based on Meshless Method

Modeling Strip Footings on Slopes Using the Material Point Method

Ultimate bearing capacity of strip footings above rectangular voids in Hoek-Brown rock masses

Analysis on coupled system of pile group and strip type footing

Dynamic Responses of Saturated Soil Foundation Subjected to a Moving Strip Load Based on the Nonlocal-Biot Theory