Abstract:For the research on real-time accurate testing technology for the explosion point spatial coordinate of munitions, its currently commonly used methods such as acoustic–electric detection or high-speed imaging are limited by the field conditions, response rate, cost, and other factors. In this paper, a method of spatial coordinate testing for the explosion point based on a 2D PSD (position-sensitive detector) intersection is proposed, which has the advantages of a faster response, better real-time performance, and a lower cost. Firstly, a mathematical model of the spatial coordinate testing system was constructed, and an error propagation model for structural parameters was developed. The influence of the position of the optical axes' intersection as well as the azimuth angle and pitch angle on the test accuracy of the system was simulated and analyzed, thus obtaining the distribution and variation trend of the overall error propagation coefficient of the system. Finally, experiments were designed to obtain the test error of the system for validation. The results show that the system test accuracy is high when the azimuth angle is 20°–50°, the overall error propagation coefficient does not exceed 48.80, and the average test error is 56.17 mm. When the pitch angle is −2.5°–2.5°, the system has a higher test accuracy, with the overall error propagation coefficient not exceeding 44.82, and the average test error is 41.87 mm. The test accuracy of the system is higher when the position of the optical axes' intersection is chosen to make sure that explosion points fall in the region of the negative half-axis of the Zw-axis of the world coordinate system, with an overall error propagation coefficient of less than 44.78 and an average test error of 73.38 mm. It is shown that a reasonable selection of system structure parameters can significantly improve the system test accuracy and optimize the system deployment mode under the long-distance field conditions so as to improve the deployment efficiency.

Study on Timing Data Gathering Across Screen Fire Measuring System

A Systemic Model for Simultaneously Measuring Three dimensional Rotation Angles of the Linear Guide Track [J]

Intelligent Measuring System for Performance Parameters of Laser Range Finder

A New Method Of Real-Time Processing For Flying Bullet Images With Hsvs

Distance Measuring Using Single-Point Laser Triangulation System Design Based on CMOS

Development of Projectile Speed Measurement Based on STC Microcomputer

Simulation Shooting Training System Based on Miniature CMOS Sensor

Accuracy calibration of the multi-light screen measurement system using array optical signal

A Method of Underwater Gun's Bullet Velocity Measuring with LinearScan CCD

Design and Detection Calculation Model of Laser Photoelectric Detection Target With Array Lens and High-Power Line Laser

A High Accuracy Time Keeping Scheme Based on GPS

Light Curtain Target Point Coordinate Measuring Method

A line laser detection screen design and projectile echo power calculation in detection screen area

Error Analysis and Optimization of Structural Parameters of Spatial Coordinate Testing System Based on Position-Sensitive Detector

Design and Realization of the Timing System of Pulsed Laser Range Finder

Linear CCD and image-subtraction analysis to detect projectile motion in real time

Design and Implementation of a Digital Shotting-collimation Computer

The Measurement of Flight Time for Pulsed Laser Ranging Based on CPLD

The Training System of Simulation Shooting with a Single Target Based on a Two-dimensional PSD

Single-event-camera-based 3D Trajectory Measurement Method for High-Speed Moving Targets

The Ammunition Projectile Test and Evaluation Used Polymer Flexible Film Sensors System Design and Application