Dynamic Strength Enhancement Mechanism of a Fully-Graded Concrete Beam

DU Cheng-bin,SUN Li-guo,JIANG Shou-yan,CHEN Yu-quan
DOI: https://doi.org/10.3876/j.issn.1000-1980.2012.03.009
2012-01-01
Abstract:The dynamic strength enhancement mechanism of a fullygraded concrete beam was studied based on mesomechanics.Assuming that the concrete composites are composed of aggregate particles,cement matrix,and an interface transitional zone(ITZ),the numerical aggregate models were generated randomly based on the actual aggregate grade of fully-graded concrete.A plastic-damage model for concrete,in which strain softening was taken into consideration,was adopted.The material parameters of the aggregate particles,cement matrix,and ITZ were identified through a static flexural-tension experiment.Based on the identified parameters,the dynamic flexural-tension failure process of the fully-graded concrete beam was numerically simulated under an impact load.The effects of inertia and strain rate on the dynamic increase factor(SDIF) were analyzed.The results show the following:(a) The inertial effect on the limited load could be neglected when the strain rate was lower than 8 s-1;when the strain rate was greater than 8 s-1,the inertial effect on SDIF of the fully-graded concrete beam increased.(b) When the strain rate was lower than 20 s-1,the strain rate had a significant effect on SDIF,whereas the SDIF was mainly controlled by the inertia effect.In addition,the effect of initial damage on the failure load of the fully-graded concrete beam was studied.
What problem does this paper attempt to address?