Abstract:The strain after rolling plays an important role in the prediction of the microstructure and properties and plate deformation permeability. So, it is necessary to establish a more accurate theoretical strain model for the rolling process. This paper studies the modeling method of the equivalent strain based on the upper bound principle and the stream function method. The rolling deformation region is divided into three zones (inlet rigid zone, plastic zone, and outlet rigid zone) according to the kinematics. The boundary conditions of adjacent deformation zones are modified according to the characteristics of each deformation zone. A near-real kinematics admissible velocity field is established by the stream function method on this basis. The geometric boundary conditions of the deformation region are obtained. The deformation power, friction power, and velocity discontinuous power are calculated according to the redefined geometric boundary conditions. On this basis, the generalized shear strain rate intensity is calculated according to the minimum energy principle. Finally, the equivalent strain model after rolling is obtained by integrating the generalized shear strain rate in time. The plate rolling experiments of AA1060 and the numerical simulations are carried out with different rolling reductions to verify the analytic model precision of the equivalent strain. The results show that the minimum and the maximum relative equivalent strain deviation between the analytic model and the experiment is 0.52% and 9.96%, respectively. The numerical calculation and experimental results show that the model can accurately calculate the strain along the plate thickness. This model can provide an important reference for the rolling process setup and the microstructure and properties prediction.

Research on Stress and Strain Distribution During Multi-Pass Conventional Spinning under Different Roller Motion Modes

Evolution of Residual Stress Based on Curvature Coupling in Multi-Roll Levelling

Numerical Simulations of Granular Material Behavior under Rotation of Principal Stresses: Micromechanical Observation and Energy Consideration

Design Research on Roller of New Fiber Carding Machine

Numerical Investigation of Effects of Deformation Allocation on Multi-Pass Conventional Spinning Process of Curvilinear Generatrix Parts

A Study of Multi-Pass Scheduling Methods for Die-Less Spinning

The central strain analytical modeling and analysis for the plate rolling process

Enhancing the Spun Yarn Properties by Controlling Fiber Stress Distribution in the Spinning Triangle with Rotary Heterogeneous Contact Surfaces

Effects of Forming Parameters on Deformation Uniformity of Thin-walled Parts during Multi-pass Spinning

Multi-pass Spinning of Thin-Walled Tubular Part with Longitudinal Inner Ribs

Plasticity Improvement of Ball-Spun Magnesium Alloy Tube Based on Stress Triaxiality

Review of Conventional Spinning Process and Its Roller Path Design Development

Experimental Methodology for Obtaining the Flow Curve of Sheet Materials in a Wide Range of Strains

Varying Feed Ratio Processing Method of Multi-Pass Die-Less Spinningbased on Hoop Strain

Effects of spinning parameters on microstructures of ellipsoidal heads during marginal-restraint mandrel-free spinning

A Numerical Study of the Effects of Roller Paths on Dimensional Precision in Die-Less Spinning of Sheet Metal

Finite element modeling and simulation of yarn in winding process

Numerical Study of Melt-Spinning Dynamic Parameters and Microstructure Development with Ongoing Crystallization

Isometric fiber distribution in the roller drafting zone

Spinning of curvilinear generatrix parts without mandrel based on main and auxiliary rollers

State of residual stress induced by cyclic rolling contact loading