Abstract:Kaplan turbine units can adjust their blades to achieve wider outputs without a significant loss of efficiency. The combination of guide vane angle (GVA) and blade angle (BA) is selected based on efficiency curves obtained from cam tests. However, the vibration characteristics are not considered in the test. The vibration and flow characteristics are complex with different combinations of guide vane and blade angles. Different cam relation selection principles lead to varying machine vibration and flow characteristics. In this research, the flow and vibration characteristics were obtained by means of field test and numerical simulation. Vibration, pressure pulsation, and other stability indicators have been extracted and investigated under off-cam conditions. The flow and variation rules of different indicators have been thoroughly researched. The findings suggest that the magnitude of vibration in the X direction surpassed that in the Y direction for the head cover, upper frame, and lower frame under 22 experimental conditions. The disparity between the head cover and upper frame in both directions was not significant, whereas a substantial contrast existed between the lower frame in the X and Y directions. The calculation results indicate that when the guide vane angle was small, vortices appeared near the high-pressure edge of the runner in the vaneless region and caused disorganized flow lines in the runner, and this complex vortex behavior led to multiple frequency components in the pressure pulsation frequency domain. The conclusions provide references for the designers of Kaplan turbine units and improves the operating safety of Kaplan turbine power stations.

Ventilation experiments of 700 MW class turbine generator

Ventilation and Stator Temperature Field of Bulb Tubular Turbine Generator

The Numerical Analysis Of Ventilation And Temperature Fields For A Bulb Tubular Turbine Generator

Circulating Efficiency Test of Domestic 600MW Units and Their Performance Optimization Analysis

Simulation Study on Closed-circuit Ventilation System of Large Vertical Hydraulic Turbine Generator

Design of the external forced air cooling control strategy for the bulb tubular turbine generator based on multi-objective optimization

Multi-physical Fields of Rotor Windings with Axial-Radial Ventilation System for 1100 MW Nuclear Half-Speed Turbine Generator

Sensitivity of Axial Velocity at the Air Gap Entrance to Flow Rate Distribution at Stator Radial Ventilation Ducts of Air-Cooled Turbo-Generator with Single-Channel Ventilation

Calculation and Analysis of the Surface Heat-Transfer Coefficient and Temperature Fields on the Three-Dimensional Complex End Windings of a Large Turbogenerator

Application Study on Low Vacuum Circulating Water Heat Supply of a 50 MW Turbine

Influence of the End Ventilation Structure Change on the Temperature Distribution in the End Region of Large Water–Hydrogen–Hydrogen Cooled Turbogenerator

The analysis of flow field in the generator ventilation channel

A Comparative Study on Coupled Fluid–Thermal Field of a Large Nuclear Turbine Generator with Radial and Composited Radial–Axial–Radial Ventilation Systems

Calculation of Ventilation Systems and Influence of Ventilation Duct Area on Temperature of Copper Shield in the End Region of Large Water-hydrogen-hydrogen Cooled Turbo-generators

Heat transfer coefficient distribution in inner surface of stator ventilation duct for large capacity air-cooled turbine generator

Calculation of Ventilation Cooling, Three-Dimensional Electromagnetic Fields, and Temperature Fields of the End Region in a Large Water–Hydrogen–Hydrogen-Cooled Turbogenerator

Study on the Internal Flow Characteristics of Long and Short Blade Runners of a 1000 MW Francis Turbine under Different Opening Conditions

Optimization of Ventilation System for a Main Power Plant in an Underground Pumped Storage Power Station

Vibration and Flow Characteristics of a 200 MW Kaplan Turbine Unit under Off-Cam Conditions

Stator Non-Uniform Radial Ventilation Design Methodology for a 15 MW Turbo-Synchronous Generator Based on Single Ventilation Duct Subsystem

Numerical Simulation of the Axial Fan of the Turbogenerator