Abstract:The microstructures and properties of Al-Mg-Si-Cu alloys were investigated by differential scanning calorimetry, Vickers hardness, electrical conductivity, tensile properties test, intergranular corrosion and transmission electron microscopy. The hardness of the alloys aged at 180°C increases to a peak value and decreases subsequently. The hardening rates of the alloys increase with the increase of Cu content, and the softening rate decreases due to overageing. The electrical conductivity of the alloys firstly decreases to a minimum value and increases subsequently. The electrical conductivity decreases with the increase of Cu content. With the Cu content increasing, the tensile strengths of the alloys in T6 and T4 increase, and the resistance to intergranular corrosion decreases, but the alloy without Cu does not present intergranular corrosion sensitivity. The kind of the precipitates in the T6 alloy varies with the Cu content increasing. β″ phase dominates in the alloys at the Cu content lower than 0.6, but β″ and Q' coexist in the alloys with Cu content of 0.9. The number density and volume fraction of the precipitates increase with the increase of Cu content and the size decreases. The precipitates are solute clusters in the T4 alloy.

Effect of Mg Content on Microstructure and Mechanical Properties of Al-Cu-Mg-Ag Alloys

Effect of Mg Content on Mechanical Properties and Microstructure of Al-4.8Cu-xMg-1.0Ag Alloys

Effects of Ag Content on Microstructures and Properties of Al-Cu-Mg Alloy

Effects of Cu and Mg content on microstructure and mechanical properties of Al-Cu-Mg-Ag alloy

Effects of Cu and Mg Contents on Mechanical Properties of Al-xCu-yMg-0.6Ag Alloy

Microstructure and Three-Point Bending Fatigue Behavior of Al-Cu-Mg-Ag Alloys with Various Mg Contents

Effect of Cu Content on Microstructure and Mechanical Properties of Al-Cn-0.4Mg-0.6Ag Alloy

Effect of Zn and Mg Content on Microstructure and Properties of Al-Zn-Mg-Cu High Strength Aluminum Alloys

Effects of Ag, Mg Micro-Alloying on Aging Characteristics and Microstructure of Al-Cu-Li Alloy

Effects of Mg content on microstructure and mechanical properties of low Zn-containing Al−xMg−3Zn−1Cu cast alloys

Influence of Mg Contents on Aging Precipitation Behavior of Al–3.5Cu–xMg Alloy

Effects of Cu Content and Cu/Mg Ratio on the Microstructure and Mechanical Properties of Al–Si–Cu–Mg Alloys

Effect of Cu Content and Zn/Mg Ratio on Microstructure and Mechanical Properties of Al–Zn–Mg–Cu Alloys

Microstructures and Fatigue Fracture Behavior of an Al–Cu–Mg–Ag Alloy with a Low Cu/Mg Ratio

Effect of Cu content on the mechanical properties of an Al–Cu–Mg–Ag alloy

Effect of Ag content on evaluated-temperature mechanical properties and thermal stability of Al-Cu-Mg-Ag Alloys

Microstructure and Mechanical Properties of Al–Cu–Mg–Mn–Zr Alloy with Trace Amounts of Ag

Research on Precipitation and Mechanical Properties of Al-Cu-0.4Mg-0.6Ag Alloy

Effect of Cu content on microstructures and properties of Al-Mg-Si-Cu alloys

Effect of minor Ag addition on microstructures and properties of Al-Mg-Cu-Li alloy with low Cu/Mg ratio