Abstract:Providing efficient ventilation in road tunnels is essential to prevent severe air pollution exposure for both drivers and pedestrians in such enclosed spaces with heavy vehicle emissions. Longitudinal ventilation methods like commercial jet fans have been widely applied and confirmed to be effective for introducing external fresh air into road tunnels that are shorter than 3 km. However, operating tunnel jet fans is energy consuming. Therefore, for small-scale (~100 m–1 km) road tunnels, mechanical ventilation methods might be highly energetically expensive and unaffordable. Many studies have found that the use of wind catchers could improve buildings’ natural ventilation, but their effect on improving natural ventilation in small-scale road tunnels has, hitherto, rarely been studied. This paper, therefore, aims to quantify the influence of style and arrangement of one-sided flat-roof wind catchers on ventilation performance in a road tunnel. The concept of intake fraction (IF) is applied for ventilation and pollutant exposure assessment in the overall tunnel and for pedestrian regions. Computational fluid dynamics (CFD) methodology with a standard k-epsilon turbulence model is used to perform a three-dimensional (3D) turbulent flow simulation, and CFD results have been validated by wind-tunnel experiments for building cross ventilation. Results show that the introduction of wind catchers would significantly enhance wind speed at pedestrian level, but a negative velocity reduction effect and a near-catcher recirculation zone can also be found. A special downstream vortex extending along the downstream tunnel is found, helping remove the accumulated pollutants away from the low-level pedestrian sides. Both wind catcher style and arrangement would significantly influence the ventilation performance in the tunnel. Compared to long-catcher designs, short-catchers would be more effective for providing fresh air to pedestrian sides due to a weaker upstream velocity reduction effect and smaller near-catcher recirculation zone. In long-catcher cases, IF increases to 1.13 ppm when the wind catcher is positioned 240 m away from the tunnel entrance, which is almost twice that in short-catcher cases. For the effects of catcher arrangements, single, short-catcher, span-wise, shifting would not help dilute pollutants effectively. Generally, a design involving a double short-catcher in a parallel arrangement is the most recommended, with the smallest IF, i.e., 61% of that in the tunnel without wind catchers (0.36 ppm).

Experimental study of natural ventilation for road tunnels with shafts

Similarity Theory in a Model Test for the Natural Ventilation of Urban Tunnels

Studying on Air Flow and Pollution of Natural Ventilation Tunnel with Shafts

Numerical study of natural ventilation in urban shallow tunnels: Impact of shaft cross section

Analytical and Numerical Study on Natural Ventilation Performance in Single- and Gable-Slope City Tunnels

Experimental study of shaft ventilation modes for road tunnels in case of fire

A Study on the Influence of Air Vents Arrangement in Natural Ventilated Tunnels

Ventilation mechanism test system for natural ventilation tunnel

Experimental study on the performance of hybrid ventilation system combining forced longitudinal flow and shaft natural ventilation in tunnels

A Model Test Study to Optimize the Ventilation System of a Long Expressway Tunnel

Natural Ventilation of a Small-Scale Road Tunnel by Wind Catchers: A CFD Simulation Study

Study on the Air Inlet Velocity and Temperature Distribution in an Inclined Tunnel with Single Shaft under Natural Ventilation

Full-scale experiment on the ventilation performance of vehicle-mounted mobile fans in a road tunnel

Experimental investigation on influence of shaft cross-sectional area on natural ventilation in urban road tunnel fires

On the Mechanism and Influence of the Delayed Effect of Longitudinal Ventilation in Urban Tunnels

Road tunnel ventilation method study based on smoke-dilution air requirement

Study on the number and spacing of ventilation shafts in a highway tunnel with longitudinal ventilation

Single-channel Blowing-in Longitudinal Ventilation Method and Its Application in the Road Tunnel

Air flow and gas dispersion in the forced ventilation of a road tunnel during construction

Experimental Study on Smoke Control Using Wide Shafts in a Natural Ventilated Tunnel

Combined Ventilation Mode in Extra-Long Road Tunnels: Energy Efficient Channel Utilization with the Inclined Shafts