Abstract:Abstract Hydro-abrasive erosion due to sediment flow often leads to the efficiency loss, seriously vibration, and sometimes even failure for Pelton turbines. This kind of erosion can be greatly intensified when the concentration of sand increases. It is of paramount importance to study the erosion mechanism for such machines, especially in Asia, where the sand concentration in many rivers is relatively higher due to some geologically young mountains like the Himalayas. In this study, the erosion patterns of the injector have been predicted at high sand concentration. The simulated scenario was based on continuous measurement of sediment flow during the flood season in an power plant. Firstly, the three-dimensional modeling for the whole flow domain of the injector with jet has been carried out by ANSYS Fluent. The free air-water flow from the injector has been simulated with the SST k-ω turbulence model, where the VOF (volume of fluid) model was implemented to capture the air-water interface. Then after tracking the particle movement in the air-water flow by the Lagrangian method, the Mansouri model was adopted to predict the erosion patterns. The erosion mechanism was explained by detailed analysis of particle impact properties like the average hits, the impact velocity, and the impact angle. The results show that the “velocity deficit region” will reduce erosion on the needle tip. In addition, abrupt geometry change can be designed at low-velocity regions to reduce erosion. This paper can provide a better understanding of the erosion mechanism, which can help to reduce wear in future designs.

Abrasive Erosion Pattern Analysis for Impeller Blades of a Slurry Pump Used in Sand Dredging

Effects of Particle Erosion on the Submersible Pump in an Ultra-High Voltage Transformer

Study on Erosive Wear and Novel Wear-Resistant Materials for Centrifugal Slurry Pumps

Slurry Flow And Erosion Prediction In A Centrifugal Pump After Long-Term Operation

An experimental insight into dynamic characteristics and wear of centrifugal pump handling multi-size particulate slurry

Research on abrasion of impeller of centrifugal slurry pump

Analysis on the Wear Characteristic of ADI Blade for Slurry Pump

Erosion Wear on Impeller of Double-Suction Centrifugal Pump Due to Sediment Flow

Numerical Investigation of the Erosion Behavior in Blades of Tidal Current Turbine

Experimental and Numerical Studies on Erosion Damage in Damping Holes on the Valve Plate of an Axial Piston Pump

Research on Wear Properties of Centrifugal Dredge Pump Based on Liquid-Solid Two-Phase Fluid Simulations

Numerical Simulation Prediction of Erosion Characteristics in a Double-Suction Centrifugal Pump

Abrasive Erosion Comparison for A Ceramics and A High Chrome Cast Iron Applied in A Slurry Pump

Numerical Analysis of Sand Erosion for a Pelton Turbine Injector at High Concentration

Numerical Simulation and Experimental Study on Sediment Wear of Fixed Guide Vanes of Hydraulic Turbines in Muddy River Based on Discrete Phase Model

Solid-liquid two-phase flow and wear analysis in a large-scale centrifugal slurry pump

CFD-DEM investigation of centrifugal slurry pump with polydisperse particle feeds

A Study of the Relationship between Sand Movement and Flow Field Distribution and Wear Causes in a Multiphase Pump

Experimental Study on Deteriorated Performance, Vibration, and Geometry Changes of an Electrical Submersible Pump Under Sand Water Flow Condition

A review on the hydraulic performance and erosion wear characteristic of the centrifugal slurry pump

Numerical Prediction of Erosion Based on the Solid-Liquid Two-Phase Flow in a Double-Suction Centrifugal Pump