Abstract:Guide vane submersible centrifugal pumps are a kind of submersible pump, and the fluid inside the pump is often mixed with gravel and other impurities during operation, affecting the pump's operating efficiency and life expectancy. However, past studies on solid–liquid two-phase flow (STF) and wear characteristics in guided vane centrifugal pumps have been limited to the particle trajectory and wear region distribution. These studies have lacked research on the effect of particles on the fluid flow and the specific amount of wear on the overflow components. Additionally, most of them have used the DPM discrete-phase model, which does not consider the particle–particle and particle–wall interactions. This paper is based on the CFD–DEM method, combined with the Archard wear model. A solid–liquid two-phase flow simulation is carried out for pumps with different particle sizes and particle shapes to analyze the particle movement inside the pump, the wear distribution and average wear amount of the overflow components, and the effect of particles on the turbulent kinetic energy of the fluid. The results show that the particles mainly collide with the leading and trailing edges of the impeller blades and the leading edge of the guide vane blades and form a buildup at the trailing edge of the concave surface of the guide vane blades, resulting in the wear being mainly distributed in these regions. With an increase in particle size and a decrease in sphericity, the average wear on the overflow components increases. The change of particle size directly affects the resistance of the fluid and the structure of the flow field, which has a large impact on the fluid flow pattern and generates large turbulent kinetic energy fluctuations. The shape of the particles only changes the structure of the local flow field, which has a small impact on the fluid flow pattern.

Analysis on the Wear Characteristic of ADI Blade for Slurry Pump

Abrasive Erosion Pattern Analysis for Impeller Blades of a Slurry Pump Used in Sand Dredging

Effects of Particle Erosion on the Submersible Pump in an Ultra-High Voltage Transformer

Research on abrasion of impeller of centrifugal slurry pump

Investigation of High-Speed Abrasion Behavior of an Abradable Seal Rubber in Aero-Engine Fan Application

High-speed Abrasion Experimental Research of an Abradable Seal Rubber

Study on Erosive Wear and Novel Wear-Resistant Materials for Centrifugal Slurry Pumps

An Effective Method for Improving the Lifetime of Double Acting Vane Pump

Evaluation of an AlSi-polyester abradable seal coating performance using high-temperature and high-velocity abrasion tests

An experimental insight into dynamic characteristics and wear of centrifugal pump handling multi-size particulate slurry

Influence of Blade Thickness on Solid–Liquid Two-Phase Flow and Impeller Wear in a Ceramic Centrifugal Slurry Pump

Abrasive Erosion Comparison for A Ceramics and A High Chrome Cast Iron Applied in A Slurry Pump

Investigation on wear induced by solid-liquid two-phase flow in a centrifugal pump based on EDEM-Fluent coupling method

Solid-liquid two-phase flow and wear analysis in a large-scale centrifugal slurry pump

Slurry Flow And Erosion Prediction In A Centrifugal Pump After Long-Term Operation

Study on Wear Characteristics of a Guide Vane Centrifugal Pump Based on CFD–DEM

Experimental Study on the Influence of Particle Diameter, Mass Concentration, and Impeller Material on the Wear Performance of Solid–Liquid Two-Phase Centrifugal Pump Blade

Experimental and Numerical Studies on Erosion Damage in Damping Holes on the Valve Plate of an Axial Piston Pump

A review on the hydraulic performance and erosion wear characteristic of the centrifugal slurry pump

Erosion Wear on Impeller of Double-Suction Centrifugal Pump Due to Sediment Flow

Research on Wear Behavior of Tools While Infeed Cutting Austempered Ductile Iron (ADI) with Ceramic Tools