Abstract:Polyethylene (PE) pipe, particularly high-density polyethylene (HDPE) pipe, has been successfully utilized to transport cooling water for both non-safety-related applications and safety-related applications in nuclear power plant (NPP). However, concerns of a lack of non-destructive examination (NDE) procedures and qualifications specialized for HDPE pipe impede its broader application. Traditional approximation without considering effects of acoustic dispersion could work for PE pipe with a small inspection depth. But for PE pipe of large size used in nuclear power plant, effects of acoustic attenuation and dispersion accumulate with depth, and have influence on waveforms of target pules, which brings great challenges to the energy concentration when performing ultrasonic phased-array inspection for PE pipe in NPP. In this paper, a theoretical method applying Szabo's causal convolutional propagation operator based on causality theory was presented to obtain wave equations of ultrasound in PE considering both attenuation and dispersion, in which attenuation coefficient and phase velocity were used to separately characterize acoustic attenuation and dispersion. Then, an experimental method using ultrasonic spectroscopy technology was proposed to confirm the proposed model, and a good agreement was obtained. The results indicated that attenuation coefficient of PE had an approximately linear relation with frequency and that phase velocity rose logarithmically with frequency. Finally, effects of attenuation and dispersion on amplitude spectrum and waveform in time domain of the target signal were investigated. Frequency downshift and time delay shift had an influence on image resolution and focus capability, and were believed to be a restriction of current inspection technology. This work also theoretically proved that lower testing frequencies (less than 2.5MHz) could improve the inspection effectiveness of the applied inspecting systems for HDPE pipes in NPP applications.

Mode Selection in Ultrasonic Guided Wave Testing Technique for Tubes and Pipes in Power Plants

Implementing Ultrasonic Guided Wave Mode Control in Hollow Cylinders

RESEARCH ON FREQUENCY DISPERSION CHARACTERISTICS OF LONGITUDINAL GUIDED WAVE IN MULTI-LAYER TUBE

Feasibility of non-destructive testing for aluminium sheaths of HV cables using ultrasonic guided waves

Evaluation of Pipe Axial Defeat Through the Use of Ultrasonic Guided Wave and Matching Pursuit

A New Procedure for Exploring the Dispersion Characteristics of Longitudinal Guided Waves in a Multi-layered Tube with a Weak Interface

Ultrasonic Guided Wave Approach Incorporating SAFE for Detecting Wire Breakage in Bridge Cable

Ultrasonic Guided Wave-Based Circumferential Scanning of Plates Using a Synthetic Aperture Focusing Technique

Research on Ultrasonic Guided Wave Dispersion Compensation for Steel Strand Defect Detection

The analysis of mechanism for generating and detecting torsional guided wave

Excitation Frequency Choice and Sensitivity Analysis in the Inspection of Pipe with Ultrasonic Guided Waves

Research and application of low-frequency eddy current detection technology for heating surface tube of power plant boiler

Non-destructive Evaluation of Spiral-welded Pipes Using Flexural Guided Waves

Parameters Choice in Detection of Viscous Liquid-Filled Pipelines with Axial Power Flow Distributions of Ultrasonic Guided Waves

Ultrasonic Guided Wave Testing Trials for Pipes

A new on-line ultrasonic thickness monitoring system for high temperature pipes

Design and experimental study of electromagnetic ultrasonic single-mode guided wave transducer for small-diameter stainless steel tubes

Multiphysics Structured Eddy Current and Thermography Defects Diagnostics System in Moving Mode.

Investigation On Acoustic Propagation Of Ultrasound In Polyethylene Pipe Used In Nuclear Power Plant

Circumferential Ultrasonic Testing for Ultra- High Pressure Vessels and Pipes(1)

Mode Conversion Behavior of Guided Wave in A Pipe Inspection System Based on A Long Waveguide